Installation Guide

Check Box for These Contents

In the event of missing or defective parts please call our customer service department

1 800 282 9346

(Mon. to Fri. 8:00 AM to 4:00 PM EST).

Shade Slat

(28) 1 1/2” x 1 1/2“ x 75 7/8” - 10819 White / 14035 Composite

Shade Slat Joiner

(14) - 10600-1 White / 14028 Composite

Shade Slat Decorative End Caps

(28) - 30030-1 White / 14032 Composite

3” Self-Auguring Stainless Steel Screw

(84) 20007 White / 20033 Composite

Tube of vinyl glue

(2) 20000 White / 20022 Composite

Tools You Will Need

• Cordless Drill

• Tape Measure

General Information

• Read Instructions through carefully before beginning assembly.

• When assembling components, place on a non-abrasive surface (i.e. shipping box) to avoid scratching.

• We recommend an area approx 5’x 8’ for unobstructed assembling.

• You should not need to use excessive force when assembling component.

Please read through before starting assembly.

ASSEMBLY

INSTRUCTIONS

12 x 12 Additional Shade Slat Kit

IMPORTANT: CHECK THE INSIDE OF YOUR EXTRUSIONS FOR ALL MATERIALS.

.1/021017

www.newenglandarbors.com

Not to Scale

The 12 x 12 Additional Shade Slat Kit is designed to compliment our 12’ x 12’ Regency, Roosevelt,

Freemont, and Kennedy Pergolas. This kit is intended to be installed simultaneously with the

pergola although retroactive installation is also an option.

PAGE 1
A S S E M B LY I N S T R U C T I O N S 12 x 12 Additional Shade Slat Kit www.newenglandarbors.com The 12 x 12 Additional Shade Slat Kit is designed to compliment our 12’ x 12’ Regency, Roosevelt, Freemont, and Kennedy Pergolas. This kit is intended to be installed simultaneously with the pergola although retroactive installation is also an option. Please read through before starting assembly. IMPORTANT: CHECK THE INSIDE OF YOUR EXTRUSIONS FOR ALL MATERIALS.
PAGE 2
STEP ONE Shade Slat Assembly 1 Assemble shade slats by first gluing the decorative end caps as shown, and then inserting the two slats into one joiner. Push firmly until extrusion bottoms out inside joiner. No screws are necessary.
PAGE 3
STEP T WO Shade Slats Installation www.newenglandarbors.com 1 Follow the pergola instructions until just before the shade slat installation. At this point, 28 shade slats are assembled (i.e. 14 from the pergola kit and 14 from this additional shade slat kit). Install the first shade slat up against the columns and install the rest of the shade slats at 3 3/8in (8.7cm) spacing. 2 Proceed with the remainder of the steps, including fastening 3in screws through the shade slats and into the rafters.