Installation Guide

12 x 16 Canvas Weave
ASSEMBLY INSTRUCTIONS
Ver 1.1/112316
www.newenglandarbors.com
This kit contains eight strips of canvas that is designed to fit the 12 x 16 Flat Top Pergola (Model: Valencia Pergola).
No hardware is required to attach the canvas to the shade slats of the pergola as hook and loop fastener strips are already sown in
at the ends of the canvases.
Check the box and make sure you have eight strips (part #10255) and that the male-female hook and loop fastener orientation is correct.
In the event of missing or defective parts, please call our customer service department at 1 800 282 9346 (Monday to Friday. 8:00 AM to
4:00 PM EST).
STEPS
Layout all eight strips of canvas and check the ends to make sure there are a female and male hook and loop fastener strip on both ends as
shown.
With the hook and loop fastener strips facing up, weave the canvas through the shade slats as shown. Note the pattern of the weave (below
one shade slats, and above one shade slats). Starting with below one shade slats, and ending with the same.
The ends of the canvases would then wrap around the end shade slats and be secured with the hook and loop fastener.
Note: Canvas strips should be removed under heavy wind or snow to prevent any ripping or damage.
Male and Female Hook and Loop Fastener Strips
End of canvas wraps around
the end shade slat as shown.
Weave with hook and loop fastener facing up.