Instructions / Assembly

2
STEP ONE
Lay out one of the posts (part 1). Measure 8” (20.3 cm) from one end of
the post and put a mark. Center the rail mount bracket (part 8) on the
post, with the open end at the 8” mark. Using two screws 5/8" (16 mm) ,
fasten the bracket to the post as illustrated. Repeat this for the second
post. Note: All screws are self-tapping and require no pre-drilling.
Take one of the posts and measure 29” (73.7 cm) from the same end of the
post as in step 1. Put a mark on the post at this distance.
Slip one of the base moldings (part 7) onto the opposite end of the post
as illustrated. Slide it up the post until the top edge of the molding is at the
29” (73.7 cm) mark.
Center another rail mount bracket on the base molding, keeping the open
end of it tight against the raised lip of the base molding trim. Fasten the
bracket in place using two 1 1/2" (38 mm) screws. Repeat steps A through
C for the other post.
Note: The distance between the two brackets should measure
approximately 18 3/4” (47.6 cm) when finished.
Cottage Picket Wings Installation
A
A
B
B
C
8” (20.3 cm)
29" (73.7 cm)
C
The Cottage Picket Wings