Instructions / Assembly

4
STEP THREE
A
A
B
C
B
Determine which side of your arbor the wings will be attached to.
Fasten a rail mount bracket to the outside of the arbor base molding in
the same manner as described in Step 1 (c). Note: If your arbor does not
have a base mold, install bracket directly on arbor (B). You will need to use
1/2” (13 mm) filler (A) as bottom rail is shorter to allow for base mold.
Using two 5/8" (16 mm) screws, fasten a second bracket to the outside
of the arbor post as illustrated. The distance between the brackets on
the arbor post must equal the distance measured between the brackets
on the wing post. Repeat steps A and B for the arbor side panel.
Using the distances shown, mark out each hole location on both
sides of the arbor. Dig out two 16” (41 cm) deep holes.
1/2” (13 mm) Filler
(used when no base trim is
present on the arbor post).
42"
(107 cm)
49"
(124 cm)
15.5" (39.4 cm)
C
Ground Level
The Cottage Picket Wings