Instructions / Assembly

5
STEP FOUR
A
Lower the wing post into the hole, while slipping each rail end into the
corresponding bracket on the arbor post. check the top rail for level,
and adjust the depth of the hole if needed. Secure the rail ends to
the brackets as described in Step 2 (a), and fill in the hole (for added
stability, use pre-mix concrete). Repeat this step for the opposite wing
panel. Note: The bottom of the wing post base molding should be at
ground level when finished.
Apply a generous amount of vinyl glue around the post. Note: The vinyl
glue should be applied below the top of the picket cap level as shown.
Slip one trim cap (part 6) over the end of each post. Slide each cap
down until the top edge is level with the top of the first picket.
Apply a bead of vinyl cement to the underside of each post cap (part
5). To ensure proper attachement to the post, apply the cement to all
internal “contact” points of the cap. Place the caps onto the end of each
post and push down firmly until the end of the post “bottoms out” on
the inside of the cap. Allow a few minutes for the cement to cure.
A
B
C
B
Level
C
Vinyl glue is to be applied
below the picket level.
www.wearevita.com
North America Toll Free Phone: [phone]