Instructions / Assembly

2
STEP ON E
Cottage Picket Gate Installation
A
A
B
B
Make sure
rails are
bottomed
out inside
the posts.
Square
C
D
Lay out one of the posts on its side, with holes facing up, and insert the
two rails. The bottom rail (holes routed one side only) goes into the
hole that is closest to the end of the post. Now insert the top rail into
the other hole.
Hold the rails into the post and now insert the rails into the other post
Lay the assembly down on a flat surface and use a square to check the
inside corners. Make sure that each rail is bottomed out inside the
posts.
Install 2 screws into each of the four places where the rail goes into the
post. Install screws on diagonal (as shown). Note: Screws are self
tapping but if you have any difficulty getting them started, pre-drill
a small pilot hole first (no larger then 1/16", or 1.5 mm)
D
Bottom Rail
Top Rail
C
The Cottage Picket Gate