Installation & Assembly

STEP ONE
2
Insert arches into arch keystone ensuring they terminate
ush to the internal connector.
Fasten the top of the arches to the keystone insert by
installing 2 1/2 in. (6.4 cm.) screws into the two anges on
either side of the top of the insert.
Invert the arch system and install four screws 2 1/2 in. (6.4 cm.)
from the bottom of the keystone into the two anges on
either side of the bottom of the insert. This will connect the
bottom of the arches to the insert.
Seal the bottom hole on keystone by inserting the bottom
plate as provided.
Install the top cap on the arch keystone. Ensure keystone
cap is pushed down rmly so the cap locks into position.
Repeat for other arch.
Insert arch rafters (8) into the holes on the arches until they
bottom out inside the arches. There are “locking tabs” located
at each end of these rafters that once inserted into the holes
will lock into place.
Fit opposite arch system over rafters.
The Nantucket Deluxe Arbor
Assemble the Arch System
1
2
3
1
4
5
NOTE: There are locking tabs located at the ends of each
rafter. Once inserted and pushed into the routed holes, they
will lock into place and cannot be removed.
7
8
6
2
7
8
3
4
5