Installation & Assembly

STEP T WO
3
The Nantucket Deluxe Arbor
STEP T WO
Insert the horizontal spindles into the middle verticle spindle
(holes on both sides).
Slide the two outer vertical spindles into position as illustrated .
Layout the bottom horizontal rail and insert the vertical
spindles.
Slide top horizontal rail into position.
Repeat for other panel.
Assemble the Side Panels
1
2
3
4
5
1
2
3
4
STEP THREE
Attach Sur-Fit Brackets
Attach Sur-Fit Brackets (using small screws) onto posts using the
pre-drilled holes as guides. Single hole on the side of brackets
to face down.
Set out one post and slide the assembled side panel into.
Fasten horizontal rails into Sur-Fit Brackets using small screws.
L ayout the opposite post and insert the nished side panel
with post connected.
Fasten horizontal rails into Sur-Fit Brackets using small screws.
Repeat for other side panel.
1
2
3
4
5
6
1
2
3
5
4
NOTE: Prior to installing Sur-Fit Brackets, insert a wood 4x4 post
approximately 5 ft. (152.4 cm.) up the inside of vinyl cavity
[purchase 4x4x8 to accomodate 3 ft. (91.45 cm.) in the ground]
if you intend to hang a gate, attach a fence or are located in a
high wind area.