Installation & Assembly

84 in
3 in
6 in
6 in
15
8 x 8 Corner Pergola
Rafter #3 Assembly
Take one of the 2x6x12’ board and cut into 7’ and 5’ sections. The 7’
section will be used for this rafter, and the 5’ section will be used
for the last rafter assembly.
Notch out the ends as shown.
Insert the board through a joiner followed by the #3 Left and #3
Right Rafters as shown. Note: the stickers indicating the rafters
should meet inside the joiner.
Center the wood insert about the rafter and fasten the joiner with
four 1 1/2” screws as shown.
1
2
STEP EIGHT
3
1
2
3
Stickers