Instruction manual

Wrapping Your Hand with VIT00396 - Dual Hand VitalWrap

Place it: Begin by placing the wrap on a flat surface. Make sure the Tubing Set is

on the right side of the wrap pointing away from user.

1. Wrap it: Place hands inside the wrap after connecting the wrap to the Tubing Set

by aligning the Orientation Dots as shown. Press both buttons on the Tubing Set

connector to connect and disconnect ( ).

2. Secure it: Adjust temperature of wrap or adjust positions to optimize comfort and

pain relief.

Wrapping Your Wrist with VIT00394 - Wrist VitalWrap

Loop it: Begin by unfolding your wrist wrap.

1. Start Wrapping: Put thumb through loop and hang the wrap off the palm of the

hand. Make sure theTubing Set connector points towards user.

2. Wrap it: Continue to wrap snugly around the wrist.

3. Secure it: Finish wrapping using the Velcro closure. Connect the wrap to the

Tubing Set by aligning the Orientation Dots as shown. Press both buttons on the

Tubing Set connector to connect and disconnect ( ).

Wrapping Your Shoulder with VIT00119 (Medium) & VIT00395

(Large) Shoulder VitalWrap

Slip it on: Begin by sliding arm through the wrap with the connector facing down

towards the elbow.

1. Adjust the underarm strap so that the wrap fits snugly.

2. Adjust chest strap. It may be necessary to adjust back strap before using wrap.

3. Finish wrapping by attaching Velcro closure under opposite shoulder. Connect

the wrap to the Tubing Set by aligning the Orientation Dots as shown. Press both

buttons on the Tubing Set connector to connect and disconnect ( ).

Wrapping Your Foot/Ankle with VIT00393 - Foot & Ankle

VitalWrap

Unfold it: Begin by unfolding the wrap and detaching all the Velcro straps.

1. Start Wrapping: Place foot inside the wrap with the connector pointing up

towards the knee.

2. Wrap it: Continue to wrap the top and bottom portion snugly around the ankle

and foot.

3. Secure it: Finish wrapping using the Velcro closure. Connect the wrap to the

Tubing Set by aligning the Orientation Dots as shown. Press both buttons on the

Tubing Set connector to connect and disconnect ( ).

1 2

1 2 3











