Instruction manual

Operating Instructions
Use VitalWear’s RecoveryWrap System for relief from pain and swell-
ing due to injury or aches and pains.
Setting Up Your RecoveryWrap System
1. Open it Up: Rotate the handle down to unlock and remove the Top Assembly.
Take it Off: Remove the Top Assembly and place it down carefully on a counter
top so that the Fluid Canister can be filled.
2. Take it off: Remove the RED caps on the dip tubes.
3. Fill it Up: Fill Fluid Canister with ice and water to a level above the line
marked minimum fill ( ), but do not fill above the line marked maximum
fill ( ).
4. Cover it Up: Place the Top Assembly on the Fluid Canister. Rotate the Top
Assembly so that it aligns and seats in the Fluid Canister notch. Then, raise
the Handle to lock the Top Assembly onto the Fluid Canister.
5. Connect Them: Connect the Tubing Set to the Fluid Connector located on the
Top Assembly. Align the Orientation Dots as shown. Press BOTH buttons
on the Tubing Set connector to connect & disconnect ( ).
6. Power it Up: Plug the electrical cord into the DC Appliance Jack located on the
Top Assembly and connect the appliance to the electrical source or plug a bat-
tery pack into the battery compartment located on the Top Assembly (see pg.15,
“Battery Operation”).
Available VitalWraps for Your VitalWear System
VIT-00001
Assembly, VitalWrap,
6x60” width
VIT-00255
Assembly, VitalWrap,
4x48” width
VIT-00118
Assembly, VitalWrap,
8x72” width
VIT-00119
Assembly, VitalWrap,
Shoulder
VIT-00122
Assembly, VitalWrap,
Cervical
VIT-00392
Assembly, VitalWrap,
Large Knee
VIT-00397
Assembly, VitalWrap,
Medium Knee
VIT-00393
Assembly, VitalWrap,
Ankle
VIT-00394
Assembly, VitalWrap,
Wrist
VIT-00395
Assembly, VitalWrap,
Large Shoulder
VIT-00396
Assembly, VitalWrap,
Dual Hand
1 2 3
4 5 6
Please contact us to find out about the latest VitalWraps that may be right for you.
13
12

