Instructions / Assembly

Installation Instructions (continued):

Installing the Faucet (See Figure 5):

1. Guide Escutcheon Plate (J) and Rubber Gasket (K) onto the

stem of Faucet (I). Slip the stem into the hole and make sure it

sits flat on the top of the sink or countertop surface.

2. From underneath the sink, slide Plastic Lock Washer (L) and Star

Washer (M) up along the stem, then screw Stem Nut (N) all

the way up the stem until it’s flush with Star Washer. Screw with

adjustable wrench until it’s slightly sung and check to make

sure the faucet spout is in the proper position.

Mounting the System under the Sink (See Figure 6):

1. Choose an easy to access area under the sink to mount the system.

Note: Mount the system to a solid cabinet wall. If a solid wall is not available, use

hollow-wall anchor bolts or toggle bolts (not included) to secure to the wall.

2. Use the Pre-Assembled Head Assembly (A) as a template, mark the holes for positioning

the system on the wall surface.

3. Insert Mounting Screws (F) into the wall with a Phillips screwdriver. Leaving approximately

3/8” of each screw exposed. Hang the system through the eyes of the bracket on the

screws. Tighten the screws to secure the system.

Figure 5.

Countertop

Figure 6.

Water Outlet

B C

Water

Inlet

Installing the Faucet (See Figure 5):

Mounting the System under the Sink (See Figure 6):