Installation Guide

4
Installation Instructions (continued):
Figure 3.
8. Tubing connection using Push-In Fittings
A. Take off blue horseshoe clip from collet. See Figure 4:
B. Pull out and discard protective plug by pushing the collet inward and holding with
fingers. See Figure 5:
C. Insert Tubing (D) into the collet. Full engagement is 3/4” length of the tubing the fitting.
See Figure 6:
NOTE: Ensure tubing is pushed all the way to backstop.
D. Put blue horseshoe clip back on collet.
E. To pull tubing out, simply repeat Steps A and B.
1. Slowly open the cold water supply valve that you closed at the beginning of this installation.
2. Open the cold water sink faucet to purge air from the system. When the water runs smooth
with no bubbles or spurting, close the faucet and check for leaks for all fittings.
3. Open the cold water sink faucet again to rinse the system.
CAUTION: Let water run 15 minutes before using.
NOTE: Initially, there may be some dark discolouration of the water (carbon deposits). This
condition is normal and will disappear quickly.
Start-up Instructions:
F
D
A
Water Inlet
Horseshoe
Clip
Collet
Minimum 2” Clearance
Shank of Faucet
Water Outlet
B
D
D
H
G
D
I
E
Figure 4. Figure 5. Figure 6.
BackstopO-Ring
3/4”