User Manual

Installation Instructions (continued):

Connecting 1/4” tubing from Water Line to System. (See Figure 6):

1. Determine the length of 1/4” Tubing (D) from Inlet Valve (G) to the inlet of Head Assembly

(A) by holding tubing in place ensuring it’s of appropriate length. Cut the tubing square

with a utility knife.

CAUTION: Don’t kink tubing as this will impede water flow.

2. Wet one end of the tubing with water and push it onto the guide tube of the valve until it stops.

3. Wrap Teflon Tape around the thread of the valve, and hand-screw the Inlet Compression

Nut (H) on the valve and tighten with adjustable wrench.

4. Push other end of the tubing into the inlet of Head Assembly (A) by referring the instruction

of “Tubing Connection with Push-in Fitting”.

Connecting 1/4” tubing from System to Faucet. (See Figure 6):

1. Determine the length of 1/4” Tubing (D) from the outlet of Head Assembly (A) to the stem of

the Faucet (I) by holding tubing in place ensuring it’s of appropriate length. Cut the tubing

square with a utility knife.

CAUTION: Don’t kink tubing as this will impede water flow.

2. Gently slide Faucet Compression Nut (Q) down over the tubing. Follow with Ferrule (P). Push

Insert (O) into the end of the tubing.

3. Wrap Teflon Tape around the thread of the stem.

4. Firmly push the tubing into the stem of Faucet (I) until it stops. Hand-screw the nut onto the

threads of the stem. Tighten with wrench.

CAUTION: Don’t overtighten the compression nut.

5. Push other end of the tubing into the water outlet of Head Assembly (A) by referring the

instruction of “Tubing Connection with Push-in Fitting.

Figure 7.

Figure 8. Figure 9. Backstop

O-Ring

11/16”

Tubing Connection with Push-in Fittings. (See Figure 7, 8 and 9):

1. Take off the blue horseshoe clip from collet. See Figure 7;

2. Pull out and discard the protect plug by pushing the collet inward and holding with fingers.

See Figure 8;

3. Insert Tubing (D) into the collet. Full engagement is 11/16” length of the tubing into the

fitting. (See Figure 9):

NOTE: Ensure tubing is pushed all the way to backstop.

4. Put blue horseshoe clip back on collet.

5. To pull tubing out, simply repeat Steps 1 to 2.

Connecting 1/4” tubing from Water Line to System. (See Figure 6):

Tubing Connection with Push-in Fittings. (See Figure 7, 8 and 9):

Connecting 1/4” tubing from System to Faucet. (See Figure 6):

Horseshoe

Clip

Collet