Installation Guide

5
Figure 5.
A
Minimum 2” Clearance
Water Outlet
B B
E
G
I
J
E
F
Installation Instructions (continued):
Water
Inlet
P
Q
R
E
Connecting the 1/4” tubing from Water Line to the System. (See Figure 5):
17. Determine the length of 1/4” Tubing (E) from Inlet Valve (G) to the inlet of Head Assembly
(A) by holding tubing in place ensuring it’s of appropriate length. Cut the tubing square
with a utility knife.
CAUTION: Don’t kink tubing as this will impede water flow.
18. Wet one end of the tubing with water and push it onto the guide tube of the valve until it stops.
19. Wrap Teflon Tape around the thread of the valve, and hand-screw the Inlet Compression
Nut (I) on the valve and tighten with adjustable wrench.
20. Push other end of the tubing into the inlet of Head Assembly (A) by referring the instruction
of “Tubing Connection with Push-in Fitting” on the next page.
Connecting the 1/4” tubing from the System to the Faucet. (See Figure 5):
21. Determine the length of 1/4” Tubing (E) from the outlet of Head Assembly (A) to the stem
of the Faucet (J) by holding tubing in place ensuring it’s of appropriate length. Cut the
tubing square with a utility knife.
CAUTION: Don’t kink tubing as this will impede water flow.
22. Gently slide Faucet Compression Nut (R) down over the tubing. Follow with Ferrule (Q).
Push Insert (P) into the end of the tubing.
23. Wrap Teflon Tape around the thread of the stem.
24. Firmly push the tubing into the stem of Faucet (J) until it stops. Hand-screw the nut onto the
threads of the stem. Tighten with a wrench.
CAUTION: Don’t overtighten the compression nut.
25. Push other end of the tubing into the outlet of Head Assembly (A) by referring the
instruction of “Tubing Connection with Push-in Fitting.