Instructions / Assembly

7
NOTE: The filters have a life expectancy between 6 to 12 months, depending on the incoming water
conditions and the amount of water the system uses. You must periodically replace the filters.
The replacement filter can be obtained online at www.ghpgroupinc.com or at the retail store the
system was purchased.
1. Turn off Inlet Valve (G), and open Faucet (J) to relieve pressure of the system. Place a tray
or towel under Filter Sumps (B) to catch excess water.
2. Unscrew the sump by turning Wrench (K) in clockwise direction and remove old cartridge.
3. Wash the sump throughout with mild soap and water and rinse thoroughly.
4. Replace new filter cartridge(s) by following the step 10 to 13 of Installation Instruction.
5. Slowly open the inlet valve that you closed at the beginning of this installation.
6. Open the Faucet (J) to purge air from the system. When the water runs smooth
with no bubbles or spurting, close the faucet and check for leaks. If any leaks, tighten the
sump as needed.
7. Open the Faucet (J) again to rinse the system.
CAUTION: Let water run 15 minutes before using.
NOTE: Initially, there may be some dark discolouration of the water (carbon deposits). This
condition is normal and will disappear quickly.
Filter Cartridge Replacement Instructions:
For further operating, installation, or maintenance assistance call GHP Group Inc. customer service department at
1 (877)-477-4768 Mon. - Fri. 8:30 a.m. – 4:30 p.m. CST or email us at [e-mail]
Troubleshooting:
Problem Possible Cause Solution
Water leaks between
Sump and Head
Loose connection of sump and
head.
Tighten with wrench.
O-rings missed or not in right
position.
Open sump to check the O-rings.
Water leaks at Push-in
Connections
Tubing is not pushing in all the way. Push tubing in as far as it will go.
Tubing end is not cut square. Push tubing out and recut to square.
Tubing is cracked or scratched. Simply cut that portion away and reinsert tubing.
Water leaks at threaded
fittings
Loose connection.
Tighten slightly more until leak stops.
Do no over-tighten.
Water has air bubbles and
is cloudy
Air in the system after installation. Will go away after water runs for a while.
Either no water flow or
very slow.
Inlet valve is closed. Turn on the valve.
Filter cartridge have become
clogged.
Replace the filter cartridge.
Tubing is kinked. Check the tubing and make smooth line.
Water tastes bad or has an
odor
The filter is expended. Replace the filter cartridge.