Instructions / Assembly

10
Step 1 Attach the drain clamp to the vertical section of the drain pipe, about 6 inches above
the trap. Make sure the opening on the drain clamp is facing towards the drinking
water faucet.
Step 2 Using the fittings hole of the drain clamp as a guide, drill a ¼” hole through one side of
the drainpipe.
Step 3 Remove the drain clamp from the drainpipe and enlarge the hole with a ½” drill bit. Use
a file to remove rough edges from the drilled hole.
Step 4 Make sure the black rubber gasket is adhered to the inside of the drain clamp and
place the drain clamp assembly over the drilled hole. Look through the hole and
position the clamp so that the center of the clamp hole is slightly higher (⁄”) than the
center of the drilled hole. Tighten the clamp securely.
Step 5 Connect ⁄” black tube to saddle clamp quick connect.
Step 1 Cleans hands before removing the plastic packaging from the RO membrane
Step 2 Remove the tube connection from the RO membrane cap.
Step 3 Loosen the cap by using the wrench provided in a counterclockwise direction.
Step 4 Lubricate the O-rings on the new membrane with water. Insert the end with the two
black O-rings first into the housing.
Step 5 Once the membrane has been inserted into the housing give a firm push to properly
seat the membrane.
Step 6 Check to see that the O-ring is in the cap properly seated. Replace membrane housing
cap and tighten with the supplied wrench in the clockwise direction.
installation of saddle dRain Clamp:
installing tHe membRane into tHe membRane Housing:
Drain Tubing
Drain Clamp
Front Plat
Quick connect
e
1/4” Bolt
Drain Pipe
1/4” Nut
Drain Clamp
Back Plate
Mount Drain
Valve Here
Never
Mount
Here
3
/
8
” Black Line
2 Rubber
O-Rings
This end inserted
into housing rst
Wrench
Tighten Housing Cap by
Turning Wrench Clockwise
Membrane Housing
2 Rubber
O-Rings