Instructions / Assembly

Pressure Tank

3.2 U.S. Gallons

Yellow Line

Blue Line

¼” Black

Drain Line

to air gap

Black

Line to drain

Air Gap Faucet

Counter top

Flow Restrictor 300ml

¼” White Line

All tubing is colour coded for ease of installation.

All connection points are colour coded with a tab block: white, yellow, blue and black.

¼” Black – Connects the waste water from the RO membrane to the Air Gap faucet

intake line

¼” White – Connects the tap water to the pre-filter

3/8” Yellow – Connects the RO membrane to the holding tank

3/8” Blue – Connects the carbon post filter to the faucet

3/8” Black – Connects from Air Gap Faucet to saddle drain

Each connection point has coloured plugs to match the

colour of the tubing that connects at that point. The plugs

must be removed before installing the tubing. Push in the

collar and pull the plug out.

Quick connect fittings are used throughout the system. To

insure an optimal seal, tubing should be cut with the end

square. An angled cut or distortion of the tubing will not

provide a proper seal and may cause leaks.

To install a tube, push in the collet until unit seats firmly. To remove a tube, push in the

collet and pull out the tube.

Reference the diagram below for colour and connection point in the RO System.

ConneCting tHe tubing:

CAUTION: Before cutting the supplied tubing measure the distance between the

components.

Insert Tubing Into Collet

Push in blue horseshoe to secure tubing

To remove, pull up horseshoe, push in collet

and pull tubing