Use and Care Manual
Operation
2. DISPENSING ROOM TEMPERATURE WATER
1. DISPENSING COLD WATER
3. ADJUSTING THE TEMPERATURE (COLD WATER ONLY)
NOTICE:
This model Water Dispenser left the factory with
the cold water temperature control factory “default setting”
positioned for “Energy Star” compliance (identied to the
side). This setting will deliver cold water temperatures
between 8°C ~ 10°C (46.4°F ~ 50°F) The cold water
temperature can be adjusted, (using a at screwdriver) by
rotating the adjustment screw clockwise or anti-clockwise
between “High” (cool) and “Low” (colder) until the desired
temperature is reached.
NOTE:
Any change/adjustment
to the cold water temperature control may effect Energy
Star efciency. If the water dispenser is not dispensing
water, there could be a possible ice build-up due to the
cold water temperature control being set too cold. If this
happens, unplug the dispenser overnight and then reset.
Set thermostat to high, slowly increasing based on your use
and need for cold water.
ENERGY STAR FACTORY
DEFAULT SETTING
Low
High
TEMP
COLD WATER