save These Instructions Conserver ces instructionS guarde estas instrucciones Point-of-Use Water Dispenser Distributeur d’eau au Point d’utilisation Dispensador de Agua a Punto de Utilización Use & Care Guide Guide d’utilisation et d’entretien Manual d uso y cuidado VWD9506W-POU VWD9506BLS-POU REV03 CAUTION: Before using water dispenser, read this manual and follow all safety rules and operating instructions.
Thank you for purchasing a vitapur® Water Dispenser. Please read the enclosed operating instructions carefully and retain this booklet for future reference. We have carefully engineered your vitapur® Water Dispenser to give you years of enjoyment and trouble free operation. IMPORTANT NOTE: Your vitapur water dispenser is designed with a special “safety” feature (float switch mechanism) that controls activation/operation of the “Kettle Feature” hot water tank heating system.
• • • 3-prong wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord plug. Do not use an adapter plug with this appliance. Do not use an extension cord with this appliance. If the power cord is too short, have a qualified electrician install an electrical outlet near the appliance. YOUR VITAPUR® WATER DISPENSER 1. Top Cover 2.
Installation INSTRUCTIONS It is highly recommended to have your water dispenser installed by a professional (licensed) plumber. If you are installing the water dispenser yourself, the following information is important: Depending on the type of plumbing in your home, (copper or flexible pipe) the following plumbing installation accessories (not included with the water dispenser) will be required to complete the installation of your water dispenser. These items can be purchased at your local hardware store.
TOOLS REQUIRED: • Plastic Pipe/Tube Cutter INSTALLATION LOCATION: Select a suitable location where the water dispenser will be installed, (in your home/kitchen) making sure you have easy access to an electrical wall outlet and cold water supply line. GETTING STARTED (MAIN WATER LINE HOOK-UP): 1. 2. 3. 4. IMPORTANT: Turn off the cold water supply. Open the cold water faucet allowing water to purge the system (to minimize water leakage clean-up).
Insert the water line into the valve until is stops (See Fig. 4) slide both the compression nut and compression ring toward the valve and tighten the nut firmly using a wrench. CAUTION: DO NOT OVERTIGHTEN (See Fig. 5). A B Fig. 4 Fig. 5 Fig. 6 8. The water dispenser is equipped with a manual “shut off” valve installed on the rear side of unit (See Fig. 6A) for easy access in case of an emergency. 9. Connect the incoming water line into the open side of the manual shut off valve (See Fig. 6B).
UNLOCKED Fig. 10 LOCKED Fig. 11 • To attach the filter to the filter head, make sure the “blue locking tab” on the front of filter head is pushed all the way up (See Fig. 10). • Screw the filter (1/4 turn clockwise) into the filter head until it stops. Push down the “blue locking tab” into the locked position (See Fig. 11) If the locking tab fails to engage, (lock) the filter is not sufficiently tightened (Re-tighten).
WATER LEAKAGE DETECTION SYSTEM: This water dispenser is equipped with a low voltage water leakage detection system located inside the base of the filter compartment and is covered by a removable drip tray (See Fig. 16). In the event any water makes contact with the leakage detection system, an audible alarm will sound (beep) continuously until the water is removed.
3. To access the reservoir system, you must remove the top cover on the dispenser (See Fig. 17) by removing the two Philips screws located at the rear of the cover (See Fig. 17A). 4. Carefully lift off the top cover. 5. Remove the black reservoir cover by carefully pulling upward (See Fig 17B). 6. If using a vitapur water dispenser cleaning solution, please follow the manufacturer’s instructions provided with the cleaning kit. If using a pre-mixed solution of 15ml (1 tbsp) bleach with 4.5L (1.
Dispensing Hot Water: WARNING: The hot water is heated to approximately 90°C (194°F). Temperatures above 52°C (125°F) can cause severe burns from scalding. DO NOT ALLOW CHILDREN TO USE THE HOT WATER DISPENSING BUTTON WITHOUT PROPER AND DIRECT SUPERVISION. The “Kettle Feature” (hot water) dispensing system on this unit is designed to save energy and money. Conventional hot water dispensing systems operate 24/7 regardless of water usage.
Clean with Vitapur water dispenser cleaning solution or mild soap and water mixture. For tough deposits, add vinegar and let soak until the deposits come loose. Then wash, rinse and dry throroughly. Put the grill back on the tray and install on the dispenser. Cleaning the Outside of the Water Dispenser The outside of the dispenser can be wiped clean with a vitapur® water dispenser cleaning solution or a mild soap and water mixture. Never use harsh chemicals or abrasive cleaners.
9. Re-install the dispenser top cover and secure using the two Philips screws. 10. Re-connect the power cord. Draining the Reservoirs: IMPORTANT! Unplug the dispenser before performing this procedure. Dispense hot water until temperature drops to a safe level to avoid the risk of scalding. 1. 2. 3. 4. Turn off the water supply, using manual shut-off valve at the rear of the dispenser. Press both dispensing buttons until water stops flowing.
No hot water. Insufficient water levels in the reservoir. Make sure all water shut-off valves are open. The unit is unplugged. Plug in the power cord. Kettle Feature button was not activated. Activate the Kettle Feature button. Temperature limit switch tripped. The temperature limit switch will re-set automatically when the temperature of the water drops. The circuit breaker in your home is tripped or the fuse is blown. Reset the breaker or replace the fuse. The unit is unplugged.
Warranty DO NOT RETURN THIS PRODUCT TO THE STORE: Please contact Customer Service at: 1-866-253-0447 or support@greenwayhp.com Greenway Home Products warrants your water dispenser to be free from manufacturer’s defects in workmanship or material under normal operating conditions for one (1) year from the original date of purchase. This warranty applies only in the country in which it is sold, and is available to the original purchaser only. This warranty is non-transferable.