Use & Care Manual

ManualsBrandsvitapur ManualsHousehold AppliancesWater Dispenser

Stainless Steel

Water Dispenser

Distributeur d’eau

en acier inoxydable

Dosificador de agua

de acero inoxidable

VWD6956BLS

CAUTION: Before using water

dispenser, read this manual and

follow all safety rules and

operating instructions.

MISE EN GARDE: Avant

d'employer votre distributeur

d'eau, lisez ce manuel et suivez

toutes les règles de sécurité et

les consignes d'utilisation.

PRECAUCIÓN: Antes de usar el

dosificador de agua, lea este

manual y siga todas las r

eglas

de seguridad e instrucciones de

funcionamiento.

Use & Care Guide

Guide d’utilisation et d’entretien

Manual d uso y cuidado

REV00

Summary of content (10 pages)

PAGE 1
Stainless Steel Water Dispenser Distributeur d’eau en acier inoxydable Dosificador de agua de acero inoxidable Use & Care Guide Guide d’utilisation et d’entretien Manual d uso y cuidado VWD6956BLS CAUTION: Before using water dispenser, read this manual and follow all safety rules and operating instructions. MISE EN GARDE: Avant d'employer votre distributeur d'eau, lisez ce manuel et suivez toutes les règles de sécurité et les consignes d'utilisation.
PAGE 2
Thank you for purchasing a vitapur® Water Dispenser. Please read the enclosed operating instructions carefully and retain this booklet for future reference. We have carefully engineered your vitapur® Water Dispenser to give you years of enjoyment and trouble free operation. IMPORTANT SAFEGUARDS • Never turn the dispenser upside down or tilt more than 45 degrees.
PAGE 3
YOUR VITAPUR® WATER DISPENSER 1. Bottle support collar 2. Ready-To-Dispense indicator lights: Red: “flashing” Heater is in operation "on” The hot water has reached its optimum temperature and is ready for dispensing Blue: "on" The cold water has reached its optimum temperature and is ready for dispensing Yellow: "on" The cleaning reminder is telling you it is time to clean your dispenser 3. 4. 5.
PAGE 4
OPERATING INSTRUCTIONS Initial Product Cleaning Procedure As with most new appliances, there is often a plastic taste upon initial start-up of the unit. It is recommended to clean the reservoir prior to first time use. 1. Make sure the unit is unplugged and the power switch is turned off. 2. Remove the bottle support collar, saturate a clean cloth with a water dispenser cleaner or vinegar and wipe the inside of the reservoir. 3. Pour the water dispenser cleaner or a mixture of 0.
PAGE 5
IMPORTANT NOTICE ABOUT LEAKING BOTTLES If you find that your dispenser is leaking, check the water bottle first! Almost all 3 and 5 gallon water bottles are recycled and handled extensively during cleaning, filling, and shipping. As a result they are very prone to developing pin holes or small cracks that can cause an overflow (or leak) when placed on top of a water dispenser. In almost all cases, there is nothing wrong with your water dispenser.
PAGE 6
Dispensing Hot Water This water dispenser has a power saving Insta-HOT button which activates the water heater only when pressed, so you get hot water on demand without the cost of constantly heating water! To dispense hot water, first press the Insta-HOT activation button. The red indicator light will begin flashing to indicate that the water heater is on and active. In approximately 3 minutes the set temperature point will be reached and the red light will stop flashing and remain on.
PAGE 7
Cleaning Your Water Dispenser IMPORTANT: Make sure you turn the power switch to the OFF position and unplug the dispenser before performing any of the following cleaning procedures. Cleaning the Outside of the Water Dispenser The outside of the dispenser can be wiped clean with a water dispenser cleaning solution or a mild soap and water mixture. Never use harsh chemicals or abrasive cleaners. Rinse thoroughly with clean water and then dry the surfaces.
PAGE 8
Cleaning the Inside of the Dispenser To prevent mineral deposits that can affect the taste and flow of the water and to ensure proper product performance, your water dispenser must cleaned every 4 months. 1. Make sure the power switch is in the OFF position. 2. Remove the water bottle and bottle support collar. 3. Drain the reservoirs. (See Draining the Reservoirs, pg. 6). Cleaning Kit 4. Pour the water dispenser cleaner or a mixture of 0.3 gal / 1 L of vinegar with 0.
PAGE 9
TROUBLESHOOTING TIPS Problem Possible Cause Suggested Solution Water dispenser or dispensing tap is leaking Small pin hole or crack in the bottle, (common with recycled water bottles) Conduct water bottle leak test outlined on page 4. Drain cap and silicone seal are not secure. Ensure seal is secure in drain plug and tighten drain cap. Water was poured directly into bottle support collar and overflowed. Drain by pressing all dispenser buttons. Possible air pocket.
PAGE 10
ATTENTION: Do not return this product to the store. For questions on operation, assembly or parts, please contact us at www.greenwayhp.com or 1-866-253-0447. FREQUENTLY ASKED QUESTIONS Q: Why is my water dispenser leaking? A: If you are experiencing a leak with your water dispenser please do the following to see if the water bottle or the dispenser is leaking. 1. Unplug the unit, turn off the power switch and remove the bottle. 2.