User manual

Quick Start
6 FS -T2001 Media Recorder
Connecting FS-T2001 to Camera's HD-SDI Port
To connect the camera and FS-T2001, follow these steps:
1. Locate the HD-SDI port on the camcorder.
Ensure that the HD-SDI output port on the camera is enabled
and outputting a valid SD/HD signal. Refer to the
camcorder's user manual for additional information.
2. Connect one end of the BNC cable to the camera's HD-SDI
output port.
3. Connect the other end of the BNC cable to the HD-SDI input
port on the FS-T2001.
Inserting and Removing SxS Media
Inserting SxS Media Into FS-T2001
FS-T2001 is compatible with SxS media. Check the Focus FS-
T2001 product page (http://www.vitecmm.com) for the latest list of
qualified media. SxS media can be inserted into the FS-T2001's
Express Card slot A and B. If being used for recording, make sure
the SxS card's write protection feature is switched off.
To insert SxS Media into FS-T2001, follow these steps:
1. Remove the SxS dust cover by lifting it from the lip
2. Insert the SxS card.
The card is keyed so that it will only insert in the correct
orientation. Never force the card into the slot.
3. Replace the dust cover.
Removing SxS Media from FS-T2001
To remove SxS media from FS-T2001, follow these steps:
1. Remove the SxS dust cover by lifting it from the lip.
2. Check the Media status then release the SxS card.
Press on it firmly and release. The card disengages and
springs forward.
3. Grasp the card and pull it from the unit.
4. Replace the dust cover.
Safely Ejecting SxS Media
It is necessary to safely eject SxS media in order to avoid
possible corruption of content on the card. To safely eject a
card, please refer to the Media Status information as detailed on
next page.