System information

SYSTEM NAME : It is used so that notification emails can be identified.!
F/W UPDATE : Firmware updates may be released periodically to enhance system performance and"
add extra features. The operator can upgrade the firmware using a USB memory stick.!
After inserting the F/W in USB or CD/DVD, Press UPDATE. Then , below menu will appear.!
After selecting the F/W from F/W list, press UPGRADE. Then, F/W upgrade is started.!
FACTORY DEFAULT : If settings have been changed , which cause erratic behavior, the factory default"
settings can be loaded.!
SYSTEM DATA : System settings can be saved to a USB memory stick. The settings can be reloaded"
in case of accidental factory reset or can be transferred to another DVR if multiple "
units need to be installed with the same settings. All information is saved apart from "
network settings and system name.!
PASSWORD: Determines the PASSWORD ON/OFF to enter specific menu.!
This will allow up to 254 DVRs to be controlled from the same keyboard.!
SYSTEM ID : If more than one DVR is connected on the same RS485 bus, each one must have a uniq
ue ID.!
Note : If use more than one DVR on stack, each DVR must have unique ID for control by Remote cont
roller.!
PROTOCOL : Must be set by Control Device.!
BAUD RATE : Must be set to match the baud rate of the PTZ controller.!
SYSTEM : CONTROL DEVICE!
27!