Specifications

ENVI Series: VTC-IR40-N

Network

General network parameters are required in this part. Please contact your network

administrator for detail.(IP Address, Netmask, Default Gateway, DNS1, DNS2)

Authentication

(Admin Password)

Password for the IP device.

(Default password for Vitek products is “root” unless already changed)

Save Configuration

Option

Select whether the configured contents is to be saved in the Camera memory or not.

• Save Configuration: Changed values will be saved in the Camera memory of the

device, which means the changes are permanent.

• Not Saving: Changed values will not be saved in the Camera memory, which

means if the IP device is turned off the changes are lost and the previous setting

will be applied back.

Click Set button to apply the changed values to IP device. If you don’t want it, click Cancel button.

When two or more IP devices are selected

You can select two or more IP devices at the same time by clicking one after another while CTRL

key is pressed. The result is shown as below.

To configure the network parameters of those devices, click the right mouse button or click

Manual IP Setup icon on the main Toolbarwith multiple IP devices selected as shown above.

Then the following window will show up.

You can modify the value of each changeable field by clicking it. The following shows an example

of entering a new value to a field.