User Manual

13
Operating Instructions
MAIN DEFAULT DESCRIPTION
ZOOM/FOCUS Sets FOCUS MODE, D-ZOOM, LENS REFRESH and LENS INIT
-
EXPOSURE
Sets EXPOSURE MODE, BRIGHTNESS, SENS-UP, AGC and
MOTION DEBLUR.
-
SCENE
ENHANCE
NORMAL
.
Press ☟’
Lens Initializing is strongly recommended at the first stage of setup menu control.
ZOOM/FOCUS > LENS INIT > Press the joystick ☟’straight down for about
2 seconds.
MENU V3.12
1. ZOOM/FOCUS
2. EXPOSURE
3. SCENE ENHANCE
4. 3D-NR
5. DAY/NIGHT
6. PICT ADJUST
7. SPECIAL
8. SYSTEM
9. EXIT
NORMAL
MID
EXT
SAVE&EXIT
OSD menu Start up
Direct Control menu
(OSD menu SET key) down to access the setup menu mode.
SCENE ENHANCE provides several ways to enhance the video
in various environments with the settings in NORMAL, WDR,
D-WDR, BLC and HLC.
NORMAL Optimized for normal indoor and outdoor in good
lighting condition.
WDR Improves the visibility for bright areas and dark
areas by double capture of image with LONG and SHORT
exposures. With WDR ON, the frame rate becomes half by the double
capture. WDR level can be selected from LOW, MID and HIGH.
Care should be taken to select this mode because video may lose
its quality in some environments by over compensation.
CVBS video signal: Connecting 2nd video to CVBS port disables
WDR function temporarily. It should be considered when installer
adjusts the video with installation monitor via CVBS video signal.
D-WDR Improves the visibility by compensating the video gain for
the dark area. Noise can increase in the dark area accordingly.
※