User Manual

9
Installation Instructions
Assembly Screw
(4x14mm)
Torque Wrench
Assembly Screw
(4x12mm)
Mounting Screw
(4x30mm)
1. Locate the mounting template at the installation position and drill the ceiling
or wall if needed.
2. Open the dome cover by loosening screws(4x12mm). Use the torque wrench
supplied.
4. Set the cameras viewing angle.
- Route the Power cable to the connecting place.
.
A
Flush mount type
A. Flush mount type:
B. Surface mount type (Option):
B
Surface mount type
3
5. Replace the dome cover to the dome base unit and tighten the assembly screws.
- Place the surface mount on pre-drilled position and attach using mounting
screws (4x30mm). Assemble the cable conduit, otherwise tighten a conduit hole
cap.
- Route the Power cable to the connecting place.
- Affix the dome base unit to the surface mount using the assembly screws
(4x14mm). Before attaching the dome base make sure the assembly holes are
aligned with the surface mount assembly holes.
See Optional Dome Mounts (pg. 3)
Flush Mount Installation
requires a Flush Mount
Decorator Plate (See
pg. 3)
See Optional Dome Mounts (pg. 3)
Assembly Screw
(4x14mm)
Torque Wrench
Assembly Screw
(4x12mm)
Mounting Screw
(4x30mm)
.
A
Flush mount type
B
Surface mount type
Flush Mount Installation
requires a Flush Mount
Decorator Plate
(See pg. 3)
Flush Mount
Decorator Plate
- Place the dome base unit on pre-drilled position and attach using mount-
ing screws (4x30mm).