User Manual

Care and Cleaning
CAUTION: Turn off your MONITOR before cleaning.
You can clean the MONITOR as required, using a soft lint-free cloth. Be sure
to occasionally dust the ventilation slots in the cabinet to help assure
adequate ventilation.
The Monitor’s screen may be cleaned with a soft, lint-free cloth as well. Take
care not to scratch or mar the screen. If necessary, you may use a cloth
dampened with warm water. While cleaning do not spray liquid directly on the
screen, or allow liquid to run down the screen and inside the Monitor. Also,
never place drinks or vases with water on top of the monitor. This could
increase the risk of fire or shock hazard or damage to the monitor.
Mounting Your MONITOR to a Wall or Pole
Caution: The wall or pole mount must bear a minimum of three times the
monitor’s net weight (consult specs on following page for weight) without
causing damage. To mount your MONITOR to a wall or pole you need to
purchase a VESA wall mount. See VITEK Models VT-LCD/WMT-R (wall) or
VT-LCD/PMT (Pole) sold separately.
1. You need to remove the base first before attaching the wall mount.
A. Place the MONITOR face down on a surface that is soft, yet strong enough
to hold the MONITOR.
B. Use a screwdriver to remove the screws from the four holes on
each side of the bottom of the Monitor’s base (only use with base)
2. Make sure all cables are already connected to the MONITOR.
3. Follow the directions included with the wall mount to mount the monitor to
the wall.
21