User manual

2-4 VITEK

2 Instrument User Manual

510731-10EN1

Unpacking Instructions Smart Carrier Station

Installation Procedure

After completing the unpacking procedure, the SCS is ready to be placed in

its permanent location. The SCS is intended for use on any normal, flat bench

top, commonly found in a microbiology lab, away from direct sunlight. Some

cables must be connected to the unit. Figure 2-2 shows the cable

connections on the back of the unit.

Figure 2-2: SCS – Cable Connections

The back panel of the base unit, shown in Figure 2-2, contains the on/off

switch, the power cord receptacle, and the connector ports for various cables.

1 — On/Off Switch

2 — DC Power Receptacle

3 — Receptacle for the Bar Code Scanner

4 — Circular Connector for the SCS Keyboard

5 — Service/Update Cable Connector