User manual

Smart Carrier Station SCS Base Unit
VITEK
®
2 Instrument User Manual 2-9
510731-10EN1
SCS Base Unit
The base unit for the SCS contains the electronic components that make its
data entry and storage functions possible. The power switch and cable
connectors are located on the back panel of the base unit.
The base unit is actually a small computer with its own processing unit,
memory, and software program. However, the program in this computer is
limited to the task of entering and storing data for a cassette.
System Physical and Electrical Requirements
These physical specifications do not include the bar code scanner or the
external power supply.
Table 2-1: Physical Characteristics
Height: 27.6 cm (10.9 in.)
Width: 30.5 cm (12.0 in.)
Depth: 23.2 cm (9.1 in.)
Table 2-2: Electrical Requirements
Input Voltages/
Currents:
100/120 VAC +/- 10% (auto range) at 0.22 amp nominal
200/240 VAC +/- 10% (auto range) at 0.11 amp nominal
50/60 Hz
Power: 27 watt (nominal)
Heat: 92 BTU/Hr (nominal)
Power Cord: Detachable 2 wire with an IEC 320 C7 appliance connector
Table 2-3: Environmental Requirements
Indoor Usage
Do not install in direct sunlight.
Pollution Degree 2 in accordance with IEC 664
Over voltage Category II per IEC 664
Ambient Room
Temperature:
15 ºC to 30 ºC