User manual

Smart Carrier Station Setup Bar Codes
VITEK
®
2 Instrument User Manual 2-11
510731-10EN1
3) Review the last two digits of the serial number (1, Figure 2-6) to
determine which generation of SCS is in use.
4) Press F2 to exit the Configuration screen.
5) Refer to Table 2-4 and print the applicable bar code figure to use to
program the bar code scanner.
IMPORTANT: Print the applicable bar code figure using a laser printer.
6) Align the scanner several inches away from the first bar code illustrated
in the applicable figure.
7) Pull the trigger on the scanner and align the red beam over the bar code.
When the scanner emits a two-toned beep, release the trigger.
8) Align the scanner several inches away from the next bar code illustrated
in the applicable figure.
9) Pull the trigger on the scanner and align the red beam over the bar code.
When the scanner emits a two-toned beep, release the trigger.
10) Repeat Step 8 and Step 9 until all bar codes in the figure have been
scanned.
Note: The bar codes are numbered in the order they should be scanned.
The scanner is now programmed.
For more information on the configuration and operation of the Smart Carrier
Station and Bar Code Scanner (including configuration for 'stand' and 'hand
held' modes) refer to the instructions provided with the scanner stand
(included with the Smart Carrier Station) and Chapter 3, SCS Configuration.
Table 2-4: Bar Code Scanner Model References
SCS Common
Name
SCS Part
Number(s)
Bar Code
Reader
Bar Code
Reference
Figure
1st Generation
or G1
530001-1
530001-2
Model 3400
(Scanner ID
Number 722106)
P/N 531130-1
(Discontinued)
Figure 2-7
Model 3800
(Scanner ID
Number IT3800)
(Programmed to
XT Mode)
P/N 514144-1
Figure 2-9