Everest Road Lytham St Annes Lancashire FY8 3AZ Tel: +44 (0) 1253 789180 Fax: +44 (0) 1253 789182 www.vitrex.co.
10 3402NDE Compact Tile Cutter Owner’s Safety and Operating Manual
Compact Tile Cutter Owner’s Safety and Operating Manual Contents Safety Instructions ..................................................3 Machine Specification & Electrical Requirements ......4 Assembly & Operating Instructions ......................5-7 Maintenance & Warranty ........................................
Safety Instructions To use this tool correctly, you must observe the Safety Regulations, the Assembly Instructions and the Operation Instructions contained in this Manual. All persons who use and service the machine must be acquainted with this Manual and must be informed about any potential hazards. Children and infirm people must not use this tool. Children must be supervised at all times if they are in the area in which the tool is being used.
Machine Specification & Electrical Requirements Power Supply Motor RPM (No load) 230v 50Hz Hi-Torque Geared Motor 4600 rpm Maximum Depth of Cut (with new blade) 25mm Maximum Depth of Cut at 45° (with new blade) 17mm Mitre Cutting Angle Cutting Angles 22.
Assembly & Operation To fit the Cutting Blade, first carefully lift the hinged section of the table top. Remove screw from splashboard and remove the splashboard to allow access. Remove blade securing nut and blade washer. Position blade against the blade carrier with the directional arrows on the blade facing anti-clockwise. Replace the blade washer and blade securing nut. Then replace the splashboard and secure with screw.
Operating Instructions Operating Instructions Press the Mitre Guide into place on the Rip Guide. For mitre cuts, raise the hinged section of the table to the required angle (22.5° or 45°) Angular Cuts Slacken the diamond-shaped knob and set the required angle of cut. Re-tighten the knob and position the tile within the jaws of the Mitre Guide.
Compact Tile Cutter Operating Instructions Operating Instructions Slide out extension table, following arrow direction. After use, clean and remove any tile debris before retracting the extension table. Locate the lugs on the extension table into the slots of the side of the main body and ensure table is level before use. Extension Table Maintenance • Always check the blade before use for cracks or signs of damage. • Ensure that the reservoir is filled up to the recommended level.
