Owner manual

ManualsBrandsVitrex ManualsPower Tools103421

PRO 750 WET SAW

Owner’s Safety and Operating Manual

103420

Read manual before use. Keep hands arms and face clear

of blade whilst in use. Always have safety guard in place

when machine is switched on at the mains.

Always wear Vitrex Protective Equipment when using

hand or power tools.

Safety First

POWER

Everest Road

Lytham St Annes

Lancashire

FY8 3AZ

Tel: +44 (0) 1253 789180

Fax: +44 (0) 1253 789182

www.qep.com

Summary of content (4 pages)

PAGE 1
03420 POWER PRO 750 WET SAW Owner’s Safety and Operating Manual Everest Road Lytham St Annes Lancashire FY8 3AZ Tel: +44 (0) 1253 789180 Fax: +44 (0) 1253 789182 www.qep.com Safety First Read manual before use. Keep hands arms and face clear of blade whilst in use. Always have safety guard in place when machine is switched on at the mains. Always wear Vitrex Protective Equipment when using hand or power tools.
PAGE 2
POWER PRO 750 Wet Saw Safety Instructions POWER PRO 750 Wet Saw Owner’s Safety and Operating Manual To use this tool correctly, you must observe the Safety Regulations, the Assembly Instructions and the Operation Instructions contained in this Manual. All persons who use and service the machine must be acquainted with this Manual and must be informed about any potential hazards. Children and infirm people must not use this tool.
PAGE 3
POWER PRO 750 Wet Saw Assembly & Operation Machine Specification & Electrical Requirements 240v 50Hz Power Supply Operating Instructions Straight Cuts 750W Motor 2800 RPM RPM (No load) 95 dB (A) Maximum Sound Level* Maximum Depth of Cut (with new blade) 25mm Maximum Depth of Cut at 45 (with new blade) 17mm O degrees Mitre Cutting Angle 0O-15O degrees Cutting Angles 17.
PAGE 4
POWER PRO 750 Wet Saw Angular Cuts Slide the Mitre Guide into place on the Rip Guide. Mitre Cuts For Mitre cuts, raise the cutting table to the required angle (15O, 30O or 45O degrees) Maintenance Consumer Advice • Always check the blade before use for cracks or signs of damage. • Do not dispose of electrical products with your normal household waste. • Ensure that the reservoir is filled up to the recommended level. Do not overfill or allow it to run dry.