Fridge Range Product Manual

28 ENG
If the refrigerator will not be used for a long time,
disconnect it from the electrical power supply,
empty it out completely, clean it and leave the
door in the “Vent Position”(*).
Defrosting the appliance
It will be necessary to defrost the refrigerator every oen when the frost builds up to a
thickness of more than three millimetres. This operation is necessary in order to guarantee
that the fridge works eciently and to avoid increasing the electricity consumption. In
order to achieve complete defrosting of the refrigerator turn the thermostat control to
the stop position. Keep the door open so that the defrosting time is quicker.
ATTENTION: Do not use mechanical devices or other means other than those recommended
by the manufacturer to accelerate the defrosting process.
ATTENTION: Do not remove the layer of frost using pointed or sharp metal tools that may
cause a puncture in the cooling plate with irreparable consequences for the appliance.
In the holding plate refrigerators, defrosting takes place automatically.
It is recommended to empty the drip tray daily.
Once defrosting has nished start up the refrigerator by returning the thermostat knob to
the desired position.
Replacing and reversing the door
To replace the door, refer to Annex 5; to change its opening direction, refer to Annex 6.
Total/Partial recess prole assembly
To assemble the recess prole, partially
unscrew the screws of the prole, sliding
it ush with the door or ush with the
casing and tighten the screws again.
Replacing the door panel
Remove the door following the instructions given in Annex 5, then follow the instructions
in Annex 7.
Replacing the LED light prole
ATTENTION: Replacing the LED light must be done by a suitably qualied person who is
able to adopt all the appropriate safety measures. Before replacing the light, make sure