Wine cellar type water cooler Model: A1313361VB USER MANUAL When using electrical appliances, basic safety precautions should be followed in order to reduce the risk of fire, electric shock and injury to persons or property. This manual contains important information describing how to safely set up, use and maintain your water cooler with Wine Cellar. SAVE THIS MANUAL FOR FUTURE USE PN 5M007963X1 V © 2012 ELECTROTEMP TECHNOLOGIES IN C.
PRODUCT FEATURES Model: A1313361VB Page 2 1 This water cooler can provide you Hot, Cold, room-temperature water and a Wine Cellar for food storage 2 Fast cooling and heating systems can provide you 80-92C hot water and 3-10C cold water with hot water capacity 4L/H and Cold water peak capacity 4L/H. The bottom Wine Cellar can chill beer, beverage, store food or make ice cubes.
SAFETY PRECAUTIONS Model: A1313361VB Page 3 To reduce risk of injury and property damage, user must read this entire manual before assembling, installing & operating dispenser. Failure to execute the instructions in this manual can cause personal injury or property damage. This product dispenses water at very high temperatures. Failure to use properly can cause personal injury.
Model: A1313361VB Page 4 SAFETY PRECAUTIONS ---Electrical Requirements Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. A 120 volt, 60 Hz., AC only, 15- amp, fused electrical supply is required. A time-delay fuse or circuit breaker is recommended.
Model: A1313361VB Page 5 TABLE OF CONTENTS Product Features 2 Safety Precautions 3 Key Information for Future Use 5 . 6 Specifications Parts & Features .. 6 Electrical diagram .. 7 8 Assembly . 9 Proper Care & Cleaning .. Operation 10 Troubleshooting 13 Limited Warranty 14 KEY INFORMATION FOR FUTURE USE Please register your dispenser immediately at www.electrotemp.com For future support please record your serial number (located on label on back of dispenser) and date purchased.
Model: A1313361VB Page 6 SPECIFICATIONS Voltage/frequency/current 120V/ 60Hz/ 5 A Refrigerant Type R-134A Cooling Power 100 W Hot Water Power 425 W Cold water capacity / Hour 1Gallon / 3.79L <10°C Hot water capacity / Hour 1Gallon / 3.79L >80°C Wine cellar temperature 3°C~20°C / 37.4°F - 68°F Wine cellar volume 5.94 Gallon / 22.5L Dimensions 102.8 cm H x 32 cm W x 38.2 cm D 40.5 inch H × 12.6 inch W × 15 inch D Net Weight 48.1Ibs / 21.
Electrical diagram Model: A1313361VB Page 7 IMPORTANT: Do NOT Return Dispenser To Store. If you have a question or problem, please contact 855-VIVA-111 for assistance.
ASSEMBLY Model: A1313361VB Page 8 Keep plastic bags away from children. 1. Remove dispenser from packaging. 2. Unpack drip tray and insert into dispenser. As shown in figure 3. Remove the bottle receptacle from packaging and insert into Stainless cold tank As shown in figure 4. Properly dispose all of packaging. 5. Find a location for your water cooler that is protected from direct sunlight and other sources of heat.
PROPER CARE & CLEANING Model: A1313361VB Page 9 General Cleaning Perform :As needed Time Required:5minutes Note :Do Not use abrasive material or chemical cleaners 1. Unplug power cord from wall outlet. 2. Clean cabinet surfaces with a soft cloth and warm soapy water. 3. Wipe dust from back of dispenser to improve efficiency. 4. Remove drip tray assembly by sliding it forward. Remove cover. Place tray and cover in dishwasher or wipe parts clean with a soft cloth and warm soapy water.
Model: A1313361VB Page 10 Operation Not : in order to prevent compressor damage, the water cooler should stand upright for at least 4 hours. Make sure the water cooler is full filled with water before plugging in power. 1. Tear off the plastic seal or label wrapping outside of the bottle cap, Place down the water bottle into the bottle receptacle vertically, the bottle cap will be pierced by the probe and bubbles will pop up while filling water into the cooler. 2.
Model: A1313361VB Page 11 2. System default temperature table Drink/Wine name Default temperature Champagne/Beer/Beverage 4 Sauvignon Blanc/Riesling/Pinot Grigio 6 Chardonnay/Rose 8 Cabernet Sauvignon/Shiraz 10 Merlot/Zinfandel Red/Malbec 12 Custom temperature 3 ~20 selectable The default drink selected when plug in: Champagne/Beer/Beverage Note: The system will go back to default setting when power failed. 3.
Model: A1313361VB Page 12 How to make “custom temperature” setting: Press the “CUSTOM TEMP” button for by single touch, the LED light below “Custom temperature” will flash, and LCD will flash 3 , To adjust the temperature you want by touching “SELECT” button. Note: the adjust range is from 3 -20 . When setting is done, system will save automatically and display will go back to default display without touching any button.
Model: A1313361VB Page 13 TROUBLESHOOTING SYMPTOMS POSSIBLE REASONS HOW TO SOLVE 1. There is no power or not plugged in. 2. Heating switch is “OFF”. 3. Plugged into power while water dispenser is not filled with water and the protection thermostat of the heater is cut off due to dry burnt. No hot water 1. There is no power or not plugged in. 2. First time cooling takes about 1 hour. 1. Plug in power. 2. Turn on switch 3. Wait for about one hour until the thermostat reset itself. 1. Plug in power.
LIMITED WARRANTY Model: A1313361VB Page 14 Electrotemp Technologies Inc., (“Vendor”) warrants to the original purchaser of this dispenser, and to no other person, that if this dispenser is assembled and operated in accordance with the printed instructions accompanying it, then for a period of ONE (1) years from the date of purchase, all parts in such dispenser shall be free from defects in material and workmanship.
名称:酒柜说明书A1313361VB(网销)-English 图号:5M007963X1 技术要求: 1.尺寸:143*210mm 2.单色印刷 3.产品符合Rosh要求 4.