Users Manual

3
Notes:
Your VivaChek™ Eco BLE Blood Glucose meter is pre-set with beep sound
function, the meter will beep when:
• set the date and time.
• turn on the meter.
• the test strip is inserted and ready to apply blood or control solution.
• sufficient blood or control solution is pulled into the test strip.
• the test is complete.
• if any error occurs during operation.
Meter Use and Precautions
• The meter is pre-set to display blood glucose concentration in either millimoles
per liter (mmol/L) or milligrams per deciliter (mg/dL) depending on which unit of
measure is standard in your country. This unit of measure cannot be adjusted.
• Do not get water or other liquids inside the meter.
• Keep the strip port area clean.
• Keep your meter dry and avoid exposing it to extremes in temperature or
humidity. Do not leave it in your car.
• Do not drop the meter or get it wet. If you do drop the meter or get it wet, check
the meter by running a quality control test. Refer to Quality Control Test on
page 14 for instructions.
• Do not take the meter apart. Taking the meter apart will void the warranty.
• Refer to the Caring for Your Meter section on page 19 for details on cleaning
the meter.
• Keep the meter and all associated parts out of reach of children.
Note: Follow proper precautions and all local regulations when disposing of the
meter and used batteries.
All Glucose systems preventive warnings with regard to EMC
1. This instrument is tested for immunity to electrostatic discharge as specified in
IEC 61000-4-2.However, use of this instrument in a dry environment,
especially if synthetic materials are present (synthetic clothing, carpets, etc.)
may cause damaging static discharges that may cause erroneous results.
2. This instrument complies with the emission and immunity requirements
described in EN61326-1 and EN61326-2-6.Do not use this instrument in close
proximity to sources of strong electromagnetic radiation. It may interfere with