User guide

1
AUDIO
SATTV
PC
VCR
DVRDVD
AUX
-/--
AV
FAV.CH
MACRO
RECALL
MENU GUIDE
INFO
EXIT
R
>
Y
B
PIP
SWAP
i
?
x
12
3
4
5
6
7
8
9
0
OK
VOL+
VOL-
CH+
CH-
RC050
8 in 1
Touch Screen
Universal
Remote Control
with
Learning Mode
Introduction
Congratulations! You have just purchased our latest 8 in 1
Touch Screen Universal Remote Control with Learning Mode.
Its comprehensive code library enables you to control the most
popular brands in the market, and its Learning Mode allows
you to add extra functions from your original remote should our
code library not support them.
Before you can operate the remote control, you will need to
programme the remote for the device you are going to control.
Please read the following instructions carefully to guide you
through the setup process.
• This manual contains two parts: The operation instructions
and the code list
• You may need this manual in the future, so please keep it for
your future reference.
Installing batteries
This remote requires 2 x 1.5V AA batteries. Follow the steps
below to install the batteries.
1.Remove the battery door located at the back of the remote
2.Observe the polarity marks inside the battery compartments
3.Insert the batteries according to the polarity marks
4.Push and close the battery door back into place.
Note:
• Always use new batteries
• It is suggested to insert the new batteries within two minutes
of removing the old ones, and not to touch any keys during
the replacement process in order to prevent any loss of the
settings.
• Do not mix old and new batteries, different types of batteries
(e.g. Standard, Alkaline, or rechargeable) , or rechargeable
batteries with different capacities.
• If you do not plan to use the remote for an extended period,
please take out the batteries from the battery compartment
and store them in a dry and cool location.
USER
GUIDE