User guide

10
commands in sequence using just one button.
You can store up to six macro commands in your RC050.
5.1 Program a Macro
To program a Macro, please follow the steps below:
1.Press and hold down the Macro key for 3 secs. The LED
turns ON when the key is pressed but turns OFF after 3
secs indicating that the key can be released.
2.Release the Macro key, the LED turns back ON
3.Press and release the Macro Digit key (numeric keys 1-6)
under which you want to store the Macro command. The
 /('ÀDVKHVRQFHDQGWKHQUHPDLQVRQ
4.Press and release the desired device key to begin
 SURJUDPPLQJWKH0DFURVWHSV/('ÀDVKHVRQFHDQG
remains on. An AUX key can be included in a macro
sequence, using its current programmed code.
5.Now press and release the buttons you would like to
activate in sequence starting with a device key. The LED
 ÀDVKHVHDFKWLPHDNH\SUHVVHG,IWKHVHTXHQFHGRHVQRW
 VWDUWZLWKDGHYLFHNH\WKH/('ZLOOÀDVKUDSLGO\WLPHV 
then remain on.
6.If you program all 16 keys including the device key into a
macro, the macro is automatically saved after the
16th key-press.
2QFH0DFURSURJUDPPLQJLV¿QLVKHGSUHVVDQGUHOHDVHWKH
 0$&52NH\WRVDYHDQGH[LWWKHPRGH7KH/('ZLOOÀDVK
slowly 4 times then turn off.
Note
• If no keys are pressed for more than 15 secs or if the macro
digit key that has previously been programmed is pressed,
 WKH/('IDVWÀDVKHVWLPHVDQGWXUQVRII
The programming mode is existed without change.
• If a key is pressed that contains a learned function, the
learned key function is assigned to the macro sequence.
• Exit key can not be programmed into macro sequence.
5.2 Performing a Macro
If you want to execute a macro that has been previously
programmed, please follow the steps below:
1.Press and release the Macro key, The LED turns on when
the key is pressed and turns off when it is released.
2.Press and release the Macro Digit key (numeric keys 1-6)
that corresponds to the Macro command sequence you
 ZDQWWRH[HFXWH/('ZLOOÀDVKRQFHWKHQUHPDLQRQ
3.After the last command of the macro sequence has been
sent, the LED turns off. The macro is executed.
Note:
• If no keys are pressed for more than 15 secs, or if a macro
digit key is pressed and no macro is stored under it, the LED
 ZLOOÀDVKIDVWWLPHVDQGWXUQRII
5.3 Deleting a Macro
If you want to delete a macro that has been previously
programmed, please follow the steps below: