User guide

ManualsBrandsVivanco ManualsOther5 IN 1 UNIVERSAL TOUCH SCREEN REMOTE CONTROL - CODE

Programming the Remote

There are 4 programming methods available for this remote :

1.Popular brand code search

2.Direct Code Entry

3.Auto code search

4.Learning Mode

Note:

• The remote control is pre-programmed for use with

Microsoft Windows XP & Microsoft Vista PC operating

systems, so no programming is required. You will however

need a Microsoft authorized Media Center Infra Red

receiver or a PC with a built-in with a Infra Red sensor.

1. Popular Brand Code Search

(Recommende

Note:

• If you are programming the remote for a brand/model that is

not listed in the Popular Brand List or the Direct Code Entry

(e.g. Wharfedale, Acoustic Solutions etc), it is recommended

that you use the Auto Code Search method (go to section 3)

or the Learning Mode (go to section 4).

• This search method is supported only in TV, SAT, DVD and

VCR Modes. You can not use this method for other devices

(If AUX is assigned to a TV, SAT, VCR or DVD, the brand

code search is also supported in AUX mode)

• There are 20 popular brands for TV, and 10 brands for SAT,

VCR and DVD listed in the Popular brand list.

Please follow the steps below

1. Turn on the device you want the remote to control, for DVD/

CD/VCR, insert a disc/tape at the same time.

2. Look up the correct number corresponding to your brand

and device type from the Popular Brand List (For example,

if your TV brand is PHILIPS, the correct number is 00, if

your VCR brand is SONY, the correct number is 2)

3. Press and hold one of the Device Keys for 3 secs (e.g. TV).

The LED turns ON when the key is pressed but turns

OFF after 3 secs indicating that the key can be released.

4. Release all keys. LED turns back ON.

5. Enter two DIGIT (00-19) keys corresponding to the TV

brand, the LED turns OFF for each key press and turns

ON after release. (e.g. 00 for PHILIPS TV)

6. If VCR, DVD, Cable or Satellite, enter one DIGIT (0-9)

key corresponding to the (SAT, CBL, DVD, CD, VCR)

brand,

the LED turns OFF for each key press and turns ON after

release. (e.g. 2 for SONY VCR)

7. Aim the remote control at your device, the Led blinks

indicating the code search has started.

8. When your device reacts (e.g. TV turns off or channel

changes), the correct code has been found, press the

corresponding device key immediately to store the code

and the remote will exit the search mode. The LED