User guide

6
5. Press and release POWER key
 (QWHUWKH¿UVWRIWKHGLJLWFRGHV\RXMXVWORRNHGXSE\
using the Numeric keys
7. The LED turns off for each key press and turns on after
release (e.g. 045)
8. After completion, if the entered code is valid, the LED
 ZLOOÀDVKWLPHVDQGWXUQV2))WRLQGLFDWHWKDWWKHFRGH
has been stored. Press EXIT to quit this mode (otherwise
the remote will remain in this mode ready for another code
entry).
9. If any key other than the numeric key and EXIT key is
 SUHVVHGWKH/('ÀDVKHVUDSLGO\WLPHVDQGUHPDLQV21
indicating an error and that the remote is ready for the code
to be re-entered.
10.Once the code has been entered successfully, check
whether the majority of your device’s function can be
operated with the remote control. If some of the features of
your devices do not work, try different codes in the code
 OLVWXQWLO\RX¿QGWKHRQHWKDWDOORZV\RXWRFRQWUROWKH
majority of your device’s functions.
11.During the above process you can press and release the
Exit key to exit the mode at any time, the LED indicator will
 ÀDVKUDSLGO\WLPHVDQGWXUQRII7KHSUHYLRXVO\
programmed code remains unchanged.
12.If no key is pressed for 15 secs, the remote will exit the
Direct Code Entry mode and LED turns off.
Note:
• If you are programming the remote for a brand/model that is
not listed in the Popular Brand List or the Direct Code Entry
(e.g. Wharfedale, Acoustic Solutions etc), it is recommended
that you use the Auto Code Search method (go to section 3)
or the Learning Mode (go to section 4).
2.1 Assigning AUX key
You can use the AUX key to set your remote control for a
second TV, VCR, SAT, CABLE, DVD, DVR or AUDIO.
For example, to control two TVs, a cable and a DVD, you need
to assign the AUX key to operate the second TV.
The operation procedure is same as the Direct Code Entry
except a fourth numeric key is required at the end of the 3 digit
code. The fourth digit for each device is listed below:
0 – TV
1 – VCR
2 – DVD/CD
3 – SAT/CABLE
4 – DVR
5 – AUDIO
For example, if you want to programme an additional TV using
the AUX function, you would follow the Direct Code Entry
procedure and add the number ‘0’ to the end of the 3 digit
code.