User guide

7
3. Auto Code Search
This operation may take several minutes to program one
device at a time as it searches through all the codes for a se-
lected device. Therefore, it is recommended that you only use
this search method after trying Popular Brand Code Search
and Direct Code Entry or if your brand or its code is not listed
in the code list at all.
Follow the steps below to program your remote using the
Quick and Auto code search.
1.Turn on the device you want the remote to control, for
DVD/CD/VCR, insert a disc/tape at the same time.
2.Press and hold down the relevant device key for 3 secs.
The LED turns ON when the key is pressed but turns OFF
after 3 secs indicating that the key can be released.
3.Release all keys. LED turns back ON.
4.Press and release Play key, the auto-code search starts.
 7KH/('ÀDVKHYHU\VHFRQGZKHQDFRGHVLJQDOLVVHQW
5.When your device turns OFF, the correct code has been
found, press and release the corresponding device key
immediately to store the code and exit the mode. The LED
 ÀDVKHVVORZO\WLPHVDQGWXUQVRII
6.If the correct code is missed, you can press and release the
Pause key during auto search to enter into Quick search
mode (the LED will remain on). In this mode you can return
to the previous code by pressing and releasing the CH- key,
allow plenty of time for your device to switch back ON (at
least 2 secs), then press CH- again. You can also use CH+
to go to the next code.
7. Once your device turns ON press and release the
corresponding device key immediately to store the code and
 H[LWWKHPRGH7KH/('ÀDVKHVVORZO\WLPHVDQGWXUQVRII
$IWHU¿QGLQJWKHFRUUHFWFRGHFKHFNZKHWKHUWKHPDMRULW\
of your device’s function can be operated with the remote
control. If some of the features of your device do not work,
 WU\WRSURJUDP\RXUUHPRWHDJDLQXQWLO\RX¿QGDFRGHWKDW
allows control of the majority of your device’s functions.
9.During the above process you can press and release the
Exit key to exit the mode at any time, the LED indicator
 ÀDVKHVUDSLGO\WLPHVDQGWXUQVRII7KHSUHYLRXVO\
programmed code remains unchanged.
Note:
 ,IDOOWKHFRGHVKDYHEHHQVHDUFKHGWKH/('ZLOOÀDVK
times, indicating the end of the code list has been reached.
The LED will remain ON and the remote in search mode.
Press EXIT to exit the mode.
• If no key is pressed for 15 secs during search mode, the
remote will exit the mode automatically and the previously
programmed code is retained.
• While the auto code search is on, if any key other than the
Pause, Exit, CH-, CH+ and device key is pressed, they are
ignored and remote remains in the code search mode.
• If you are programming the remote for a brand/model that is
not listed in the Popular Brand List or the Direct Code Entry