Operation Manual

(GB) Instructions
Inserting the batteries
Open the battery compart-
ment on the underside of
the remote.. Then insert 2
AAA batteries. Make sure
that the polarity is correct:
the "+" and "-" markings on
the batteries and in the
compartment must match.
- To check functionality,
press the POWER button. If
everything is correct the red
lamp flickers when the but-
ton is pressed.
Adapting to appliances
In order to control your appliances you must adapt or
set the remote control to them. There are two ways of
doing so:
Direct control code entry
Example: Setting to control a Panasonic television
set:
1. The attached list gives, for example, the
Panasonic Code 436.
- Please make sure you have selected the code from
correct list for television sets (TV).
2. Press OK button and a appliance button, e.g.
TV, simultaneously until the
lamp (LED) lights constantly.
3. Then press number but-
tons (e.g. 4 3 6) in sequence.
4. Once the numbers have
been entered the lamp goes
out and the remote control is
ready to control your appli-
ance.
5. Finally, test the control
code setting by trying to con-
trol, in this example, your tele-
vision set. If it does not work at
all or not correctly try a differ-
ent code from the list or the
code search (see below).
To set the remote control for
other appliances, proceed in
the same way. Instead of the
TV appliance button, press
another button e.g. SAT/DVB
(SAT, DECODER) or
DVD/BLU RAY (UR 1300
only).
- You terminate the mode by
pressing any device button or
by code input interruption of
more than 10 seconds.
If lamp flashes twice code was not accepted and code
input can be started again.
Code search
If the brand of your appliance is not in the list or none of
the codes given fits, we recommend a code search.
Vivanco GmbH, D-22926 Ahrensburg, E-Mail: [e-mail], Helpline: [phone]
2