User's Manual
Table Of Contents
- Copyright © 2004, Vivato, Inc.
- Who Should Read This Document?
- Printing This Document
- VIVATO, INC. END USER LIMITED WARRANTY AND LICENSE TERMS
- Safety Information
- FCC Declaration of Conformity
- Conventions Used in This Document
- Contact Information
- VIVATO, INC. END USER LIMITED WARRANTY AND LICENSE TERMS 3
- Safety Information 9
- Introduction 23
- Installation 29
- Initial Configuration Using the Built-In Web Pages 35
- Using the Main Configuration Web Pages 51
- Network Configuration Web Pages 55
- Security Configuration Web Pages 71
- Monitoring Clients and System Operations 79
- Services, Password, Config, and Firmware Web Pages 85
- Diagnostics Web Screen and Help 93
- Configuration Using The Command Line Interface 95
- Network Monitoring 145
- Verifying Wi-Fi Operation 149
- Dynamic Assignment of Client IP Addresses 153
- Updating AP/Bridge Firmware 159
- Introduction
- Powered Ethernet
- Omni-directional Antennas
- Ethernet and Serial Ports
- Reset To Factory Defaults
- Metal Enclosure
- IEEE 802.11 ISM-Band Channel Operation
- Multi-AP/Bridge Operation for Extended Coverage
- Basic Service Set Operation
- Web Page or Command Line Interface Configuration
- Network Configuration Examples
- Specifications
- Shipping Contents
- Installation
- Initial Configuration Using the Built-In Web Pages
- Using the Main Configuration Web Pages
- Network Configuration Web Pages
- Security Configuration Web Pages
2 Vivato Wi-Fi AP/Bridge User Guide Copyright © 2004, Vivato, Inc.
Copyright © 2004, Vivato, Inc.
All rights reserved. No part of this document may be reproduced in any form or by any means, electronic or mechanical,
including photocopying, recording, or by any information storage and retrieval system, without written permission from
Vivato, Inc.
“Vivato” is a U.S. registered trademark of Vivato, Inc.
Who Should Read This Document?
The Vivato Wi-F AP/Bridge and Wi-Fi Base Station system introduces a new category of Wi-Fi products. Anyone installing
this product, configuring this product for operation, or performing network management operations involving this product,
should read this document before working with the Wi-Fi AP/Bridge.
Printing This Document
To print this document from the User Guide.PDF file, open the file in Adobe® Acrobat® or Acrobat Reader® and select
File>Page Setup. Configure your printer to print 8.5”x11”, portrait orientation, 2-sided. Unless you need the entire manual
printed, Vivato suggests that you print only the required portion(s).