User's Manual
Table Of Contents
- Copyright © 2004, Vivato, Inc.
- Who Should Read This Document?
- Printing This Document
- VIVATO, INC. END USER LIMITED WARRANTY AND LICENSE TERMS
- Safety Information
- FCC Declaration of Conformity
- Conventions Used in This Document
- Contact Information
- VIVATO, INC. END USER LIMITED WARRANTY AND LICENSE TERMS 3
- Safety Information 9
- Introduction 23
- Installation 29
- Initial Configuration Using the Built-In Web Pages 35
- Using the Main Configuration Web Pages 51
- Network Configuration Web Pages 55
- Security Configuration Web Pages 71
- Monitoring Clients and System Operations 79
- Services, Password, Config, and Firmware Web Pages 85
- Diagnostics Web Screen and Help 93
- Configuration Using The Command Line Interface 95
- Network Monitoring 145
- Verifying Wi-Fi Operation 149
- Dynamic Assignment of Client IP Addresses 153
- Updating AP/Bridge Firmware 159
- Introduction
- Powered Ethernet
- Omni-directional Antennas
- Ethernet and Serial Ports
- Reset To Factory Defaults
- Metal Enclosure
- IEEE 802.11 ISM-Band Channel Operation
- Multi-AP/Bridge Operation for Extended Coverage
- Basic Service Set Operation
- Web Page or Command Line Interface Configuration
- Network Configuration Examples
- Specifications
- Shipping Contents
- Installation
- Initial Configuration Using the Built-In Web Pages
- Using the Main Configuration Web Pages
- Network Configuration Web Pages
- Security Configuration Web Pages
26 Vivato Wi-Fi AP/Bridge User Guide Copyright © 2004, Vivato, Inc.
Network Configuration Examples
Introduction
Network Configuration Examples
The AP/Bridge can be deployed in four wireless network configurations:
• Access Point (AP). As an access point (AP)
connected directly to a wired LAN, the AP/Bridge
provides a connection point for wireless users and,
if more than one AP is connected, users can roam
from one area to another without losing their
connection to the network. See "Access Point
Location" on page 30.
• Coverage Filler for a Vivato Wi-Fi Base Station
using WDS. With radio frequency (RF) systems,
there can be coverage gaps or voids due to physical
barriers or radio interference. Combining the Vivato
VP1200 Wi-Fi Base Station with the Vivato Wi-Fi
AP/Bridge can provide effective coverage in an area
with poor quality or inadequate coverage. By
placing the Wi-Fi AP/Bridge within the line of sight
of the Vivato Base Station, the Vivato Wi-Fi
AP/Bridge can propagate Wi-Fi to areas with weak
or blocked coverage. See "Hole Filler Location Example" on page 31.
• Wireless Backhaul to a Wi-Fi Base Station.
With a Vivato VP1210 Wi-Fi Base Station, the only
external connections required are AC power and
Ethernet. AC power is often readily available
outside buildings, but providing Ethernet to an
outdoor environment is not always possible. The
AP/Bridge can connect to Ethernet inside a building
to provide wireless backhaul for the outdoor base
station using one Wi-Fi channel, leaving another
channel free for client connections through the
outdoor base station. See "Wireless Backhaul Example" on page 32.
• Repeater to provide range extension. The Wi-Fi
AP/Bridge can extend the range of a base station
when acting as a repeater, either in conjunction with
a Vivato Wi-Fi Base Station or with other Vivato
AP/Bridges. One radio is used to establish a
long-range connection with the Wi-Fi Base Station
or AP/Bridge, and the other radio is used for Wi-Fi
(BSS) service. This can expand the distance and
coverage area for enhanced flexibility. See "Range
Extension Positioning" on page 32.