User's Manual
Table Of Contents
- Copyright © 2004, Vivato, Inc.
- Who Should Read This Document?
- Printing This Document
- VIVATO, INC. END USER LIMITED WARRANTY AND LICENSE TERMS
- Safety Information
- FCC Declaration of Conformity
- Conventions Used in This Document
- Contact Information
- VIVATO, INC. END USER LIMITED WARRANTY AND LICENSE TERMS 3
- Safety Information 9
- Introduction 23
- Installation 29
- Initial Configuration Using the Built-In Web Pages 35
- Using the Main Configuration Web Pages 51
- Network Configuration Web Pages 55
- Security Configuration Web Pages 71
- Monitoring Clients and System Operations 79
- Services, Password, Config, and Firmware Web Pages 85
- Diagnostics Web Screen and Help 93
- Configuration Using The Command Line Interface 95
- Network Monitoring 145
- Verifying Wi-Fi Operation 149
- Dynamic Assignment of Client IP Addresses 153
- Updating AP/Bridge Firmware 159
- Introduction
- Powered Ethernet
- Omni-directional Antennas
- Ethernet and Serial Ports
- Reset To Factory Defaults
- Metal Enclosure
- IEEE 802.11 ISM-Band Channel Operation
- Multi-AP/Bridge Operation for Extended Coverage
- Basic Service Set Operation
- Web Page or Command Line Interface Configuration
- Network Configuration Examples
- Specifications
- Shipping Contents
- Installation
- Initial Configuration Using the Built-In Web Pages
- Using the Main Configuration Web Pages
- Network Configuration Web Pages
- Security Configuration Web Pages
38 Vivato Wi-Fi AP/Bridge User Guide Copyright © 2004, Vivato, Inc.
Configuration Connections
Initial Configuration Using the Built-In Web Pages
Figure 1—Enabling Automatic IP Address Assignment on Your Wireless Client
Step 5. Shut down your computer.
Step 6. Follow the steps described below for the type of connection you are using (wired or
wireless).
1
2
3
3
Make sure this is selected
to use APIPA.
Start > Settings > Network Connections
3
4
Make sure this is selected
to use APIPA.