User's Manual
Table Of Contents
- Copyright © 2004, Vivato, Inc.
- Who Should Read This Document?
- Printing This Document
- VIVATO, INC. END USER LIMITED WARRANTY AND LICENSE TERMS
- Safety Information
- FCC Declaration of Conformity
- Conventions Used in This Document
- Contact Information
- VIVATO, INC. END USER LIMITED WARRANTY AND LICENSE TERMS 3
- Safety Information 9
- Introduction 23
- Installation 29
- Initial Configuration Using the Built-In Web Pages 35
- Using the Main Configuration Web Pages 51
- Network Configuration Web Pages 55
- Security Configuration Web Pages 71
- Monitoring Clients and System Operations 79
- Services, Password, Config, and Firmware Web Pages 85
- Diagnostics Web Screen and Help 93
- Configuration Using The Command Line Interface 95
- Network Monitoring 145
- Verifying Wi-Fi Operation 149
- Dynamic Assignment of Client IP Addresses 153
- Updating AP/Bridge Firmware 159
- Introduction
- Powered Ethernet
- Omni-directional Antennas
- Ethernet and Serial Ports
- Reset To Factory Defaults
- Metal Enclosure
- IEEE 802.11 ISM-Band Channel Operation
- Multi-AP/Bridge Operation for Extended Coverage
- Basic Service Set Operation
- Web Page or Command Line Interface Configuration
- Network Configuration Examples
- Specifications
- Shipping Contents
- Installation
- Initial Configuration Using the Built-In Web Pages
- Using the Main Configuration Web Pages
- Network Configuration Web Pages
- Security Configuration Web Pages
42 Vivato Wi-Fi AP/Bridge User Guide Copyright © 2004, Vivato, Inc.
Configuration Connections
Initial Configuration Using the Built-In Web Pages
Note: As you are configuring the Wi-Fi AP/Bridge’s security settings, you will have to
enable each corresponding security setting in your client to re-enable wireless access
to the Wi-Fi AP/Bridge. For example, after enabling WEP on the Wi-Fi AP/Bridge
during the initial configuration, the AP/Bridge will require the use of WEP and the
correct encryption key on your client to re-access the Wi-Fi AP/Bridge after reboot.
Step 6. Select “Connect” to begin associating with the Wi-Fi AP/Bridge.
Step 7. Launch a web browser in your computer. All popular browsers are supported. The
minimum recommended display resolution is 800 x 600 pixels. The webpages are
accessed using a secure socket layer (SSL) connection.
Step 8. Enter the following Wi-Fi AP/Bridge IP address in the Address/Location field in your
browser: https://169.254.20.1. The Wi-Fi AP/Bridge’s login prompt appears on your
browser.
Step 9. Enter the default password: vivato
Step 10. Click on Login to display the initial Quick Setup page.
Important
Only the “Read” level password is needed the first time you access the Quick Setup web pages
to configure and reboot the Wi-Fi AP/Bridge. However, the next time you access the Quick
Setup pages you are also required to enter the Enable password before you are allowed to
make any changes to the configuration. The Enable password is created during the initial
configuration.
vivato