User's Manual
Table Of Contents
- Copyright © 2004, Vivato, Inc.
- Who Should Read This Document?
- Printing This Document
- VIVATO, INC. END USER LIMITED WARRANTY AND LICENSE TERMS
- Safety Information
- FCC Declaration of Conformity
- Conventions Used in This Document
- Contact Information
- VIVATO, INC. END USER LIMITED WARRANTY AND LICENSE TERMS 3
- Safety Information 9
- Introduction 23
- Installation 29
- Initial Configuration Using the Built-In Web Pages 35
- Using the Main Configuration Web Pages 51
- Network Configuration Web Pages 55
- Security Configuration Web Pages 71
- Monitoring Clients and System Operations 79
- Services, Password, Config, and Firmware Web Pages 85
- Diagnostics Web Screen and Help 93
- Configuration Using The Command Line Interface 95
- Network Monitoring 145
- Verifying Wi-Fi Operation 149
- Dynamic Assignment of Client IP Addresses 153
- Updating AP/Bridge Firmware 159
- Introduction
- Powered Ethernet
- Omni-directional Antennas
- Ethernet and Serial Ports
- Reset To Factory Defaults
- Metal Enclosure
- IEEE 802.11 ISM-Band Channel Operation
- Multi-AP/Bridge Operation for Extended Coverage
- Basic Service Set Operation
- Web Page or Command Line Interface Configuration
- Network Configuration Examples
- Specifications
- Shipping Contents
- Installation
- Initial Configuration Using the Built-In Web Pages
- Using the Main Configuration Web Pages
- Network Configuration Web Pages
- Security Configuration Web Pages
44 Vivato Wi-Fi AP/Bridge User Guide Copyright © 2004, Vivato, Inc.
Entering the Initial Configuration Information in the Quick Setup
Pages
Initial Configuration Using the Built-In Web Pages
Read Password Setup
The read password protects unauthorized viewing of configuration settings.
Figure 4—Read Password Setup Page
• Current “Read” Password: Enter the current password used to allow you to view, but not alter,
the Wi-Fi AP/Bridge’s configuration. The password is “vivato” when the Vivato
Wi-Fi AP/Bridge is delivered.
• New “Read” Password: Enter a new password to allow you to view the configuration web
pages.
• New “Read” Password Verification: Enter the new password again.
• Back: Return to the initial Quick Setup screen.
• Continue: Select this control after entering all of the requested information. The settings on
this form will not take effect until you select this command.
• Skip Setup: Selecting this control takes you to the configuration web pages without changing
any of the settings on the Setup screen. You should only use this function after you have
already filled out all of the information on the Setup screen before and have selected
Continue to enter those settings.