User's Manual
Table Of Contents
- Copyright © 2004, Vivato, Inc.
- Who Should Read This Document?
- Printing This Document
- VIVATO, INC. END USER LIMITED WARRANTY AND LICENSE TERMS
- Safety Information
- FCC Declaration of Conformity
- Conventions Used in This Document
- Contact Information
- VIVATO, INC. END USER LIMITED WARRANTY AND LICENSE TERMS 3
- Safety Information 9
- Introduction 23
- Installation 29
- Initial Configuration Using the Built-In Web Pages 35
- Using the Main Configuration Web Pages 51
- Network Configuration Web Pages 55
- Security Configuration Web Pages 71
- Monitoring Clients and System Operations 79
- Services, Password, Config, and Firmware Web Pages 85
- Diagnostics Web Screen and Help 93
- Configuration Using The Command Line Interface 95
- Network Monitoring 145
- Verifying Wi-Fi Operation 149
- Dynamic Assignment of Client IP Addresses 153
- Updating AP/Bridge Firmware 159
- Introduction
- Powered Ethernet
- Omni-directional Antennas
- Ethernet and Serial Ports
- Reset To Factory Defaults
- Metal Enclosure
- IEEE 802.11 ISM-Band Channel Operation
- Multi-AP/Bridge Operation for Extended Coverage
- Basic Service Set Operation
- Web Page or Command Line Interface Configuration
- Network Configuration Examples
- Specifications
- Shipping Contents
- Installation
- Initial Configuration Using the Built-In Web Pages
- Using the Main Configuration Web Pages
- Network Configuration Web Pages
- Security Configuration Web Pages
Copyright © 2004, Vivato, Inc. Vivato Wi-Fi AP/Bridge User Guide 51
Navigating the Main Web Page Configuration Screens
Using the Main Configuration Web Pages
Using the Main Configuration Web Pages
The Quick Setup screens are used to configure the Wi-Fi AP/Bridge for basic, secured Wi-Fi operation.
All of the settings configured on the Quick Setup screens, and many additional settings, are available
on the main configuration pages.
Navigating the Main Web Page Configuration Screens
The Home page is the default configuration screen that appears after initially configuring the Wi-Fi
AP/Bridge. Select one of the tabs (such as Security) to view and configure other settings.
Each main topic screen contains links to access associated settings (see below). For example, the Home
page has sub-menus titled Summary and Quick Setup. The sub-menu heading in bold (in this case
“Summary”) is the page currently being displayed.
In the upper-right corner of every page is the Enable Mode link. Unless you have already entered the
enable password on the Quick Setup page during the current configuration session, you need to select
Enable Mode and enter the enable password to change configuration settings. When you have finished
configuring the Wi-Fi AP/Bridge, select Logout of Vivato Vision to end your configuration session.
Figure 9—Accessing Settings From the Home Configuration Screen
Click here to log out of
the current configuration
session.
Enable Mode
System Information
Currently Associated Clients
Services Information
Security Information
Network Information
Monitoring Information
Icon Legend