User's Manual
Table Of Contents
- Copyright © 2004, Vivato, Inc.
- Who Should Read This Document?
- Printing This Document
- VIVATO, INC. END USER LIMITED WARRANTY AND LICENSE TERMS
- Safety Information
- FCC Declaration of Conformity
- Conventions Used in This Document
- Contact Information
- VIVATO, INC. END USER LIMITED WARRANTY AND LICENSE TERMS 3
- Safety Information 9
- Introduction 23
- Installation 29
- Initial Configuration Using the Built-In Web Pages 35
- Using the Main Configuration Web Pages 51
- Network Configuration Web Pages 55
- Security Configuration Web Pages 71
- Monitoring Clients and System Operations 79
- Services, Password, Config, and Firmware Web Pages 85
- Diagnostics Web Screen and Help 93
- Configuration Using The Command Line Interface 95
- Network Monitoring 145
- Verifying Wi-Fi Operation 149
- Dynamic Assignment of Client IP Addresses 153
- Updating AP/Bridge Firmware 159
- Introduction
- Powered Ethernet
- Omni-directional Antennas
- Ethernet and Serial Ports
- Reset To Factory Defaults
- Metal Enclosure
- IEEE 802.11 ISM-Band Channel Operation
- Multi-AP/Bridge Operation for Extended Coverage
- Basic Service Set Operation
- Web Page or Command Line Interface Configuration
- Network Configuration Examples
- Specifications
- Shipping Contents
- Installation
- Initial Configuration Using the Built-In Web Pages
- Using the Main Configuration Web Pages
- Network Configuration Web Pages
- Security Configuration Web Pages
Copyright © 2004, Vivato, Inc. Vivato Wi-Fi AP/Bridge User Guide 75
Security Settings
Security Configuration Web Pages
Configuring WEP in Your Client
See "Security>WEP" on page 71 for a description of WEP.
With the client enabled and close enough to the Wi-Fi AP/Bridge to receive its wireless signal,
use the following steps to configure WEP after accessing the Wireless Network Connection
Properties (described in the previous section). If the AP/Bridge is not close enough to the client
to receive its signals, or the AP/Bridge is turned off, you can manually enter its ESSID in the
“Network name (SSID):” field.
Step 1. Click on the Wireless Networks tab in the Wireless Network Connection window and
select the Vivato entry (see Figure 15— Configuring WEP in Your Client on page
75). If the ESSID for the Wi-Fi AP/Bridge’s wireless interfaces has been changed, use
that entry instead.
If you are not receiving the Wi-Fi AP/Bridge’s signal (no ESSID is shown), verify that
a wireless interface has been enabled on the Wi-Fi AP/Bridge. See "Network>Wireless
Interfaces" on page 66.
Step 2. Click Configure to display the WEP settings.
Step 3. Check the box next to “Data encryption (WEP enabled)”.
Step 4. Un-check the box for automatic WEP key assignment and enter the WEP key(s). WEP
keys are automatically assigned only when using 802.1x security.
Figure 15—Configuring WEP in Your Client
2
1
3
4
3
Vivato
Un-check this box...
and enter your WEP key information
in these fields.