User's Manual Part 1
Table Of Contents
- Copyright © 2004, Vivato, Inc.
- Who Should Read This Document?
- Printing This Document
- VIVATO, INC. END USER LIMITED WARRANTY AND LICENSE TERMS
- Safety Information
- Conventions Used in This Document
- Contact Information
- VIVATO, INC. END USER LIMITED WARRANTY AND LICENSE TERMS 3
- Safety Information 9
- Introduction 23
- Installation 29
- Initial Configuration Using the Built-In Web Pages 35
- Using the Main Configuration Web Pages 51
- Network Configuration Web Pages 55
- Security Configuration Web Pages 71
- Monitoring Clients and System Operations 79
- Services, Password, Config, and Firmware Web Pages 85
- Diagnostics Web Screen and Help 93
- Configuration Using The Command Line Interface 95
- Network Monitoring 145
- Verifying Wi-Fi Operation 149
- Dynamic Assignment of Client IP Addresses 153
- Updating AP/Bridge Firmware 159
- Introduction
- Powered Ethernet
- Omni-directional Antennas
- Ethernet and Serial Ports
- Reset To Factory Defaults
- Metal Enclosure
- IEEE 802.11 ISM-Band Channel Operation
- Multi-AP/Bridge Operation for Extended Coverage
- Basic Service Set Operation
- Web Page or Command Line Interface Configuration
- Network Configuration Examples
- Specifications
- Shipping Contents
- Installation
- Initial Configuration Using the Built-In Web Pages
- Using the Main Configuration Web Pages
- Network Configuration Web Pages
- Security Configuration Web Pages
Copyright © 2004, Vivato, Inc. Vivato Wi-Fi AP/Bridge User Guide 43
Entering the Initial Configuration Information in the Quick Setup
Pages
Initial Configuration Using the Built-In Web Pages
Entering the Initial Configuration Information in the Quick Setup Pages
Enter the information in the Setup Type screen and select Continue to continue to the Read Password
settings. Continue to fill in the requested information on each screen until all of the Quick Setup screens
have been configured and the Wi-Fi AP/Bridge is rebooted using the new settings. It is important that
you do this before proceeding to change any other configuration settings when you first configure the
Vivato Wi-Fi AP/Bridge.
The Quick Setup screens are displayed automatically the first time you access the configuration web
pages. To access the Quick Setup screens at a later time, select Quick Setup on the Home configuration
page.
Setup Type
The settings made on the Quick Setup screens can be used to configure the Wi-Fi AP/Bridge before
using it, or to create a template to use as a starting point for future configuration.
Quick Setup Type
• Select “local” to use the Quick Setup settings to configure the Wi-Fi AP/Bridge.
• Select “save locally as template” to save the Quick Setup configuration as a file called
“template-config” without actually changing the AP/Bridge’s configuration. This allows
you to create a configuration file to use as a base line for configuring other Wi-Fi
AP/Bridges, or to use this file in the future to configure this Wi-Fi by renaming it
“startup-config” and rebooting this AP/Bridge.