User's Manual Part 1
Table Of Contents
- Copyright © 2004, Vivato, Inc.
- Who Should Read This Document?
- Printing This Document
- VIVATO, INC. END USER LIMITED WARRANTY AND LICENSE TERMS
- Safety Information
- Conventions Used in This Document
- Contact Information
- VIVATO, INC. END USER LIMITED WARRANTY AND LICENSE TERMS 3
- Safety Information 9
- Introduction 23
- Installation 29
- Initial Configuration Using the Built-In Web Pages 35
- Using the Main Configuration Web Pages 51
- Network Configuration Web Pages 55
- Security Configuration Web Pages 71
- Monitoring Clients and System Operations 79
- Services, Password, Config, and Firmware Web Pages 85
- Diagnostics Web Screen and Help 93
- Configuration Using The Command Line Interface 95
- Network Monitoring 145
- Verifying Wi-Fi Operation 149
- Dynamic Assignment of Client IP Addresses 153
- Updating AP/Bridge Firmware 159
- Introduction
- Powered Ethernet
- Omni-directional Antennas
- Ethernet and Serial Ports
- Reset To Factory Defaults
- Metal Enclosure
- IEEE 802.11 ISM-Band Channel Operation
- Multi-AP/Bridge Operation for Extended Coverage
- Basic Service Set Operation
- Web Page or Command Line Interface Configuration
- Network Configuration Examples
- Specifications
- Shipping Contents
- Installation
- Initial Configuration Using the Built-In Web Pages
- Using the Main Configuration Web Pages
- Network Configuration Web Pages
- Security Configuration Web Pages
Copyright © 2004, Vivato, Inc. Vivato Wi-Fi AP/Bridge User Guide 57
Network Settings
Network Configuration Web Pages
Network>General
The General Network Settings are used to specify other devices in your network that the Wi-Fi
AP/Bridge must communicate and the routes used to get there.
Create a New Route
Routes tell the Wi-Fi AP/Bridge where to send packets destined for specified IP addresses.
• Name/Destination: Enter the host name or IP address prefix of the destination to which
you are trying to connect. For example, if a host called “bonanza” is at IP address
192.163.20.17, you could either enter “bonanza” or “192.163.20.0”. When entering a
host name, the host name and its IP address must first be entered into the host table using
the Create a New Host function.
• Gateway: Enter the IP address of the gateway used to access addresses on the destination
subnet.
• Netmask: Enter the subnet mask that defines the range of IP addresses for this route.
Current Routing Information
The Current Routing Information table indicates how packets within specified IP address ranges
are directed (routed). In the example below, all packets addressed to the 192.165.0.0 base IP
address that are within the Netmask of 255.255.255.0 are routed through the default bridge - br0.